Central Site Remote Access Switch 705A DMINISTRATIVE C ONSOLE COMMANDS T ABLEmodem upgrade modem# >installs new modem firmware onto specified modemmodem devices displays active modem connectionsneif displays the interface tablepkt capture specifies which packets will be captured by the packetcapture feature (all, reqd, pend, actv, idle, or none)pkt mac enables the MAC address monitor displaypkt [on/off] enables or disables the Packet Capture featurepkt display displays captured packetspkt load loads previously saved Packet Capture file into memorypkt save saves captured packets to a disk fileprimcsm displays message indicating whether or not CSM acting asa Primary Servicepswd (GUEST) changes password for current access levelquit terminates system programradius chap attempts a RADIUS authentication session using CHAPradius iphost attempts a RADIUS authentication session using IP Hostresolutionradius ipres attempts a RADIUS authentication session using IPresolutionradius macres attempts a RADIUS authentication session using MACresolutionradius pap attempts a RADIUS authentication session using PAPrestore copies backup config files into current filesrestart restarts the system program remotely using Telnetsentry ace attempts an authentication session using ACEsentry radius attempts an authentication session using RADIUSsentry status displays current status of user level authentication serverssentry log logs rejection messages from the authentication serverser stats displays current serial interface statistics for each V.35 orRS232 line attached to card in specified slot.ser clear clears current serial interface statistics for each V.35 orRS232 line attached to card in specified slot.Command Use
