| 
Central Site Remote Access Switch 555T RACE M ESSAGESX.25 Trace MessagesIn - X25 CONNECTION CONFIRMATION ConnId= Access=RemDteAddr=The system has received a connect message from the network. This indicates that a new call is nowestablished.In - X25 CONNECTION INDICATION ConnId= Access=RemDteAddr=The system has received an incoming call from the network. The system will respond with aconnect or a disconnect message.In - X25 DATA LCN , bytesData transfer.In - X25 DCE Clear Conf LCN , bytesThe DCE is confirming that an SVC call has been cleared by the DTE.In - X25 DCE Interrupt LCN , bytesAn interrupt packet has been received from the DCE. Flow control procedures do not apply tointerrupt packets.In - X25 DCE Intr Conf LCN , bytesThe DCE is confirming that an interrupt packet has been received.In - X25 DCE REJ LCN , bytesThe DCE has detected a packet sequence error.In - X25 DCE Restart Conf LCN , bytesThe DCE is confirming that all virtual circuits have been reset.In - X25 DCE RNR LCN , bytesThe DCE is not ready to receive packets from the DTE.In - X25 DCE RR LCN , bytesThe DCE is acknowledging data packets from the DTE.In - X25 Diagnostic LCN , bytesThe DCE is providing a diagnostic packet with a cause and an error code.In - X25 DISCONNECT CONFIRMA]TION Connid= Access=The system has received a disconnect confirmation message from the network. This is usuallyreceived after a call disconnect is either initiated by the system or the network.In - X25 DISCONNECT INDICATION ConnId=< connection Id > Access=< access index > Cause=for disconnect> Diag=The system has received a disconnect message from the network.In - X25 Incoming LCN , bytesAn SVC call has been received from the DCE.In - X25 Reset Ind LCN , bytesThe DCE is resetting a virtual circuit.In - X25 Restart Ind LCN , bytesThe DCE is resetting all virtual circuits. |
