USER’S GUIDE498 CyberSWITCHDM card failed FLASH download bad xx SRECThe Digital Modem card has failed the firmware update due to a corrupt file. Contact yourDistributor or Customer Support.DM card in slot has bad FLASHThe FLASH memory on the Digital Modem card has been identified as bad during an attempt toupdate or access it. Contact your Distributor or Customer Support.DM card in slot in unknown stateThe Digital Modem card is in an unrecognizable state. Reseat the card in its ISA slot, and/or checkthe MVIP cabling. If the problem persists, contact your Distributor or Customer Support.DM card in slot is not functionalThe system was unable to initialize the Digital Modem in the specified slot correctly. Check allswitch and/or jumper settings on the board to ensure they match the values in CFGEDIT. If theboard is configured properly, and this message still appears, contact your Distributor or CustomerSupport.DM card in slot will receive new firmwareInformational message stating that the system has detected that the current firmware of thespecified modem is a lower revision level than what is supported in the currently installedsoftware. For 56K modem technology, the system will attempt to update the card. For modemtechnology other than 56K, the upgrade command must be used to upgrade the firmware revision.Watch for subsequent log messages to ensure the update is successful.DM card in slot failed FLASH downloadThe system has failed to successfully update the firmware revision of the Digital Modem card.Contact your Distributor or Customer Support.DM card in slot FLASH download completeInformational message stating that the system has successfully updated the firmware present onthe Digital Modem card.DM card in slot is initializingInformational message when digital modem card first powers up; card in process of initializing.DM card in slot is not usable, could not upgradeThe modem firmware upgrade process failed for this card. Call your Distributor or CustomerSupport.DM card in slot is reinitializingThis message may display after the system attempts a Digital Modem initialization on power up.If the system determines the Digital Modem card needs new firmware, or if the Digital Modem didnot initialize correctly, it will try again. Watch for subsequent log messages to determine if a courseof action is necessary.DM card in slot signals it is operationalInformational message stating that the Digital Modem is now ready for use.DM card type configured in slot does not existUsing the resource database, the system has tried to initialize a Digital Modem card that doesn’texist. Check all switch and/or jumper settings on the board to ensure they match the values in
