Cabletron Systems Cabletron CyberSWITCH CSX5500 User Manual

Also see for CyberSWITCH 5500: Quick start Manual

Contents

USER’S GUIDE190 CyberSWITCHb. Press 2 at the above menu to enter the device’s AppleTalk address. If the device is over anunnumbered link, enter 0.0. If the device is over a MAC dial-in port, you may either enteran address, or leave the value at “none”.c. Press 3 at the above menu, then follow the on-screen instructions to configure whether ornot dial out to this device is allowed for this device.d. Press 4 at the above menu to specify an AppleTalk routing protocol the system should usewith this device. The options are None or RTMP. Currently RTMP is only supported fordevices who will be dialing into the CyberSWITCH via a MAC dial-in port.Note: If you are configuring a device for AppleTalk Remote LAN, leave the above AppleTalkinformation at the default values (DISABLED, None, DISABLED, None).Refer to AppleTalk Configuration Elements for more information.13. To enter any needed bridge information for this device, select Bridge from the Device TableMenu. The following screen will be displayed:You may enable or disable bridging for this device. If this device is to use a Remote LANinterface or Remote LAN port, enable bridging. If you want dial out capabilities to this device,enable Make calls for Bridge data.For IP Remote LAN networks, you must explicitly configure the IP (Sub)Network number.For IPX Remote LAN networks, you may configure the IPX external network number, or youmay leave the value at NONE. The IPX Spoofing Options for IPX Remote LAN devices are notavailable at this time. For additional information, please refer to the Configuring IPX chapter,Remote LAN Devices.For AppleTalk Remote LAN networks, you may configure the AppleTalk network number/range (used on the Remote LAN for this device), or you may leave the value at NONE.14. To enable per-device compression information, select Compression from the Device TableMenu. The following menu will then be displayed:a. If compression is not already enabled for this device, press 1 and follow the onscreeninstructions to change the configuration to enabled.b. If the remote device does not use 1 as the starting PPP STAC-LZS sequence number, press2 to enter a new value for the starting sequence number.Device Bridging: (device = "DAN")1) IP (Sub)Network number NONE2) Bridging ENABLED3) Make Calls for Bridge data NONE4) IPX Remote LAN Network Number NONE5) IPX Spoofing Options6) AppleTalk Network Number NONESelect function from above or for previous menu:Device Compression Menu: (device = "DAN")1) Compression ENABLED2) Starting PPP STAC-LZS Sequence Number 1Select function from above or for previous menu: