| 
Central Site Remote Access Switch 495SYSTEM M ESSAGESSystem Message SummaryData link test successful: DSL , CES 1This message applies for 1TR6 BRI only. If Layer 1 is established, a test will be done to determine ifthe data link can be established. This message indicates successful test results.Data link up: Slot= Port= Ces=The data link on the specified line is active and can be used for establishing switched connections.DCE Data Rate is invalid on FrStartPVCThe user has configured a data rate which is inconsistent with the application. This can only happenwith serial lines such as V.35 where the data rate must be specified in bits-per-second and theconfigured rate is not valid.Dedicated connection down: The dedicated connection is down. Switched backup connections will be used, if available. Thismessage will occur if the other system is down, or if the network interface line is not connected, orif the authentication of the remote device failed.Dedicated connection to device up: ,The indicated dedicated connection is operational.[DHCP-P] Failed to close UDP port after terminating last DHCP clientAn internal error occurred in the DHCP Proxy Client. When all DHCP client invocations areterminated, the UDP ports used by the DHCP Proxy Client should be closed. Contact yourDistributor or Customer Support.[DHCP-P] Failed to close UDP port (x), erc = This message appears when the DHCP Proxy Client is being disabled from Manage Mode and itencounters an error while trying to close one or both of the UDP ports that it has open. Contact yourDistributor or Customer Support.[DHCP-P] Failed to de-register with the IP Address Pool Manager, erc = This message indicates that a failure was encountered by the DHCP Proxy Client while it was beingdisabled. It was unsuccessful in its attempt to de-register as a provider of “DHCP” addresses forthe IP Address Pool. Contact your Distributor or Customer Support.[DHCP-P] Failed to open UDP port for first DHCP clientAn internal error occurred in the DHCP Proxy Client. When the first DHCP client invocation starts,the UDP ports used by the DHCP Proxy Client should open. Contact your Distributor or CustomerSupport.[DHCP-P] Failed to open UDP port (x), erc = This message appears when the DHCP Proxy Client is being enabled and it encounters an errorwhile trying to open one or both of the UDP ports that it requires for operation. Contact yourDistributor or Customer Support.[DHCP-P] Failed to register with the IP Address Pool Manager, erc = This message indicates that a failure was encountered by the DHCP Proxy Client while it was beingenabled. It was unsuccessful in its attempt to register as a provider of “DHCP” addresses for the IPAddress Pool. Contact your Distributor or Customer Support. |
