Cabletron Systems Cabletron CyberSWITCH CSX5500 User Manual

Also see for CyberSWITCH 5500: Quick start Manual

Contents

Central Site Remote Access Switch 483SYSTEM M ESSAGESSystem Message Summary[ACCT] Warning code: TimeoutThis message is logged when there is no communication with the server. Either the accountingserver is not up and running, or it cannot access the IP address. Verify the configuration of theserver.ACE authentication is not available. You must first ENABLE ACE user level authentication.An attempt was made to configure the Terminal Server Security for ACE and ACE was notconfigured on the CyberSWITCH.Activation Failure- Session NOT activeAn error has been detected in the R2 signaling procedure, and will typically result in a failed call.The error was due to unrecognizable or incorrect information. If problem persists, contact yourDistributor or Customer Support.Adapter does not respond: adapter # ’x’The WAN card initialization subsystem encountered an error on the indicated adapter. Restart thesystem. If the problem persists, the indicated adapter card may be faulty and you should contactyour Distributor or Customer Support.Adapter # ’x’ failed to initializeThe operational software on the indicated adapter card failed to signal that initialization wascompleted. Restart the system. If the problem persists, the indicated adapter card may be faulty andyou should contact your Distributor or Customer Support.Adapter # ’x’ failed to respond from bootstrapThe WAN card initialization subsystem encountered an error on the indicated adapter whiledownloading the bootstrap program. Restart the system. If the problem persists, the indicatedadapter card may be faulty and you should contact your Distributor or Customer Support.Adapter failed to respond while programming: adapter 'x'The WAN card initialization subsystem encountered an error on the indicated adapter whileprogramming the hardware. Restart the system. If the problem persists, the indicated adapter cardmay be faulty and you should contact your Distributor or Customer Support.Administrative Session using ACE does not support password change.Passwords may only be changed via the ACE Server administrator initiation. During anadministrative login, the user attempted to change password. ACE only supports password changeinitiated by ACE Server administrator.AppleTalk routing initialized successfully.This message is posted when the system AppleTalk routing feature has initialized successfully.AppleTalk routing RTMP initialization error, AppleTalk disabledAppleTalk is disabled because there is an initialization problem with the Routing TableMaintenance Protocol (RTMP). Contact your distributor or Customer Support.AppleTalk routing ZIP initialization error, AppleTalk disabledAppleTalk is disabled because there is an initialization problem with the Zone InformationProtocol (ZIP). Contact your distributor or Customer Support.AppleTalk successfully initialized on LAN port with address .This message is posted when the specified AppleTalk LAN port has initialized successfully.