| 
USER’S GUIDE524 CyberSWITCHPVC for DLCI > not ACTIVEA frame was received on the PVC associated with the indicated DLCI which was not active. This isa temporary condition, and results from an asynchronous operation between the network andcustomer-premise equipment regarding the state of the individual PVCs. If this problem persists,contact your Distributor or Customer Support.PVC not allocated for The frame relay software received a frame from the network on PVC using the indicated DLCIwhich has not yet been configured. It is likely that there is a configuration mismatch between nodesin the network such that a node is transmitting data to the node logging this error via a valid butas yet unallocated PVC.PVC rcv wait q already fullIndicates a lack of system resources to handle the level of traffic being experienced. Contact yourDistributor or Customer Support.RADIUS authentication is not available. You must first ENABLE RADIUS user level authentication.An attempt was made to configure the Terminal Server Security for RADIUS and RADIUS was notconfigured on the CyberSWITCH.R2: Clearing chan due to abnormal forward receptionR2: Memory Slip Overflow DetectedR2: CLEAR_BACKWARD timed out on chan R2: Transmit Overflow DetectedThese messages may result in dropped calls. They indicate that the line may be extremely noisy, orthat the modem installed in the system is not configured correctly (A-law vs. mu-law). Checkconfiguration before proceeding.R2: Illegal ...R2: Received unknown ...R2: Unable to send host ...These illegal events typically result in a failed call. Contact your Distributor or Customer Support.R2: Task unable to allocate Scheduling Timer. Shutting down task.R2: Unable to restart Scheduling Timer.These are non-recoverable conditions in the R2 system. Most likely, an attempt was made to installR2 signaling on a system that does not support it. Contact your Distributor or Customer Support.R2 not capable of Multichannel or Non-circuit callsThis illegal event typically results in a failed call. Contact your Distributor or Customer Support.RBS: Channel - Backing off of channel, GLARE detected.An incoming and outgoing call occurred on the indicated channel at roughly the same time. Thesystem discontinued the outgoing call in order to allow the incoming call to be established. |
