Cabletron Systems Cabletron CyberSWITCH CSX5500 User Manual

Also see for CyberSWITCH 5500: Quick start Manual

Contents

USER’S GUIDE596 CyberSWITCHUnable to prompt for device name at this timeIndicates that thecall command would prompt you for a device name, but the necessaryresources are not available. The recommended actions are as follows:1. If possible, enter the device name on the command line.2. If the device name cannot be entered from the command line (for example, the devicename contains command line delimiters of a space, a comma, a colon, or a tab), thedevice can wait for a few minutes and see if any resources become available.3. If actions 1 and 2 are ineffective, this may indicate an internal problem in the System,please inform your service representative of the occurrence.C ALL D ETAIL R ECORDING COMMANDSThe following commands are used to monitor and verify the call detail recording (CDR) feature.cdr statsDisplay the CDR statistics. Refer to Call Detail Recording Statistics, for the available statistics andcorresponding definitions.cdr stats clearClears the CDR statistics; setting them all to zero.cdr verifyGenerates a “verify” report to all servers that have been configured for CDR use, then typicallydisplays a list of all servers to which it sent the messages. If no log servers or events areconfigured for CDR, it will report that no messages were sent.Refer to Log Commands for the commands that will allow you to display or erase CDR log reports.C ALL R ESTRICTION C OMMANDSWhen the Call Restriction feature is enabled on the CyberSWITCH, the following command isavailable through the administration console:cr statsDisplays the current Call Restriction statistics. Refer to Call Restriction Statistics, for a list ofavailable statistics and their definitions.Other Call Restriction commands are available through Dynamic Management. Refer toConfiguring Call Control for these commands.