USER’S GUIDE446 CyberSWITCHThe same example that is used in the previous section is used to verify IP RIP input processing ona WAN interface.1. Make sure that a dedicated connection between system and Router is up and operational. Onthe CyberSWITCH administration console:Type:cs2. Determine if system has learned the route to 192.1.2.0 from the Router. On the CyberSWITCHadministration console:Type:ip routeIf the route to 192.1.2.0 is displayed, the IP RIP input processing is operational.3. If the route is NOT displayed, try the following:a. Verify that the IP RIP Receive Control is set to the proper RIP version that the Routeris using. Refer to page 443 for instructions regarding check RIP versions.b. Enter theip rip stats administration console command. Look for theIfStatRcvResponses counter for the interface. This statistics is the number of RIP updatemessages received on the interface. If the total number of these counters is 0, check theRouter to verify that it is configured to send IP RIP update messages.c. Also look for the IfStatRcvBadPackets and IfStatRcvBadRoutes counters.• If these counters are not 0, there may be something wrong with the Router.• If these counters are 0, there is an unexpected condition present within theCyberSWITCH system software. Contact Customer Support.IPXIPX ROUTER I NITIALIZED ?1. Determine if IPX routing has been initialized on the CyberSWITCH by viewing the systemmessages. To display the messages enter the following console command:dr 2. Look for the following IPX message among the system messages:[IPX] IPX router is initialized successfullyAlso, for each IPX interface that has been configured, the following interface initializationmessage should be displayed among the system messages.[IPX] Network initialized successfully on xxxxxxxx:xxxxxxxxxxxxNote: Other messages may also be displayed with the IPX router initialization messages.If you see these IPX router initialization messages, the IPX router is initialized.3. If these IPX router initialization messages are NOT displayed, look for the following message:[IPX] Initialization failureThis message indicates an internal error. Contact Customer Support
