| 
USER’S GUIDE518 CyberSWITCHManual restart initiated on DM board in slot There was an attempt to restart the specified Digital Modem with themodem restart command.Check subsequent log messages to verify the command was successful.Max ATI3 retries exceeded on modem of slot Modem in slot did not respond to the proper modem revision string on powerup. Call Customer Support.Maximum call charges exceeded for monthThe configured maximum for monthly call charges has been exceeded.Maximum call minutes per day limit (x) has been reachedThe described limit has been exceeded. The next log message will indicate whether calls will stillbe allowed or not.Maximum call minutes per month limit (x) has been reachedThe described limit has been exceeded. The next log message will indicate whether calls will stillbe allowed or not.Maximum calls per day limit (x) has been reachedThe described limit has been exceeded. The next log message will indicate whether calls will stillbe allowed or not.Maximum calls per month limit (x) has been reachedThe described limit has been exceeded. The next log message will indicate whether calls will stillbe allowed or not.MCP detected channel failure: A link has failed for some abnormal reason and the indicated channel has been disconnected. Thismessage is generally preceded by another message which indicates the underlying protocol. Referto that message. If this does not pinpoint the problem, check the application on the remote deviceto see if it is working correctly.Memory Access TimeoutThis indicates a TDM bus connector failure that is specific to the TDM bus connecting a primaryrate and a basic rate adapter. Ensure that the TDM bus has been correctly connected to the twoadapters. If problem continues, contact your Distributor or Customer Support.MEMORY LIMITED - COMPRESSION connections availableWhere “x” is equal to the number of connections that can be supported. There is not enoughmemory available to support the number of compression connections being allocated. You maywant to purchase more memory for your system. Contact your Distributor or Customer Support.Mild congestion CLLM received for DLCI A CLLM message was received indicating mild congestion may be expected on the PVC associatedwith the indicated DLCI.Mismatch of configured and installed DM card in slot The switch and/or jumper settings on the specified Digital Modem card are not properly set tomatch how the card is configured in software. Check the hardware and software configuration andrestart. |
