| 
USER’S GUIDE528 CyberSWITCHSemipermanent. Device "x" disconnected by adminThe administrator has issued adisc device command. Therefore, the systemwill not attempt to call the indicated device again. Issuing thecall device name>command will make device “x” semipermanent again.Semipermanent. Device "x" has a smaller Initial Data Rate than Base Data Rate. No connection made.The semipermanent feature will make enough calls to meet but not exceed the device’s Initial DataRate. In this case, the Base Data Rate (normally 56 or 64 Kbps) is larger than the device’s Initial DataRate. The semipermanent feature cannot make any calls, or it will exceed the Initial Data Rate.Reconfigure your data rates.Semipermanent. Device "x" has had "y" bandwidth drops within "z" seconds. This device is considered tohave failed remote authentication.Because the local system cannot always be aware of remote authentication failures, and becausethere is no way to recognize remote authentication failures in the system once the remote end isauthenticated, the semipermanent feature will try to determine them by detecting excessive remotebandwidth drops. The remote device must drop a call 10 times within a 10 minute period to triggerthis event.Will try again in "w" minutes.This will be displayed directly beneath the above message if a Session Interval isconfigured for the device.Semipermanent. Device "x" reconnected by admin.The administrator has issued thecall device command after issuing thedisc device name> command. This restarts the semipermanent feature for theindicated device.Severe congestion CLLM received for DLCI A CLLM message was received indicating severe congestion may be expected on the PVCassociated with the indicated DLCI.Signal for unknown CallCmd task: Contact your Distributor or Customer Support.SIG_notify Failure. Called Session is not Active.An error has been detected in the R2 signaling procedure, and will typically result in a failed call.The error was due to unrecognizable or incorrect information. If problem persists, contact yourDistributor or Customer Support. Cfg ErrorLine vs. adapter configuration error. A line is configured for port that does not exist onthe adapter in slot . |
