| 
Central Site Remote Access Switch 425V ERIFYING THE B ASE SYSTEMRemote Device Connectivityfix> ConnId= Id>In - CONNECT Call Id= Id> Slot= Port= #>Chans= channel map> Ces= endpoint suf-fix> ConnId= Id>If the system reports these messages, then continue with the next step.If the system does NOT report these messages, the remote device is not correctly connect-ing to the system. Check and verify the configuration of the remote device.4. If the system displays the following message among the system messages:Security Rejection-Invalid Calling Line Id - <#>the network is indicating a calling line identifier that is not configured for any valid device inthe system Device list. The number “# ” indicates the actual number presented by the network.5. For Remote Bridge Devices:If the system displays the following messages among the system messages:Security Rejection - Caller did not negotiate securitySecurity Rejection - No Bridge Address given by callerSecurity Rejection - Unknown Calling BridgeSecurity Rejection - No Password given by callerSecurity Rejection - Invalid Password givenSecurity Rejection - HDLC not supported by the callerreview the system configuration for the Device List. You can also refer to the System Messageschapter for the message meanings and the appropriate actions to be taken.6. For IP Host Devices:If the system displays the following messages among the system messages:IP Call Dropped: ID_RSP was not received from remoteIP Call Dropped: XID was not received from remoteIP Security Rejection - Digit string wrong lengthIP Security Rejection - Invalid Security ID string>Review the system configuration for the Device List. You can also refer to the System Messageschapter for the message meanings and the appropriate actions to be taken. The first twomessages indicate that the system did not receive the required protocol data. The second twomessages indicate that the security configuration is incorrect.7. For PPP Devices:If the system displays any error or warning messages that begin with the following prefixes:[PAP].....[CHAP].....[AUTH].....There probably is an error in the remote device configuration. Review your remote deviceconfiguration. You can also refer to the System Messages chapter for the message meanings andthe appropriate actions to be taken. |
