5 -4 User Constants Settable in Quick Programming ModeThe minimum user constants required for Inverter operation can be monitored and set in quick programmingmode. The user constants displayed in quick programming mode are listed in the following table. These, andall other user constants, are also displayed in advanced programming mode.Refer to the overview of modes on page 3-4 for an overview of quick programming mode.Con-stantNumberName Description SettingRangeFactorySettingChangeduringOpera-tionControl Methods MEMOBUSRegis-terV/fV/fwithPGOpenLoopVec-torFluxVec-torA1-02ControlmethodselectionUsed to select the control method forthe Inverter0: V/f control1: V/f with PG2: Open loop vectorThis constant is not initialized by theinitialize operation.0 to 20 No Q Q Q Q 102H0 to 3b1-01 ReferenceselectionSet the frequency reference inputmethod.0: Digital Operator1: Control circuit terminal (analoginput)2: MEMOBUS communications3: Option board4: Pulse train input0 to 4 1 No Q Q Q Q 180Hb1-02OperationmethodselectionSet the Run Command inputmethod.0: Digital Operator1: Control circuit terminal(sequence input)2: MEMOBUS communications3: Option board0 to 3 1 No Q Q Q Q 181Hb1-03StoppingmethodselectionUsed to set the stopping methodused when a Stop Command is input.0: Deceleration to stop1: Coast to stop2: DC injection braking stop (Stopsfaster than coast to stop, noregenerative operation.)3: Coast to stop with timer (RunCommands are disregardedduring deceleration.)0 to 3*1 0 No Q Q Q Q 182HC1-01 Accelera-tion time 1Sets the acceleration time to acceler-ate from 0 to the maximum outputfrequency, in 1-second units. 0.0 to6000.0*210.0 sYes Q Q Q Q 200HC1-02 Decelera-tion time 1Sets the deceleration time to deceler-ate from the maximum output fre-quency to 0, in 1-second units.Yes Q Q Q Q 201HC6-01 CT/VTselection0: CT (low carrier, constant torque,150% per minute)1: VT (high carrier, variable torque,120% per minute)0 or 11*3No Q Q Q Q 223H0 *33: Flux vector