7 -26 If the Motor Rotates Even When Inverter Output is StoppedIf the motor rotates even when the Inverter output is stopped, the DC injection braking is insufficient. If themotor continues operating at low speed, without completely stopping, and after a deceleration stop has beenexecuted, it means that the DC injection braking is not decelerating enough. Adjust the DC injection brakingas follows:• Increase the constant b2-02 (DC Injection Braking Current) setting.• Increase the constant b2-04 (DC Injection Braking (initial excitation) Time at Stop) setting. If OV is Detected When the Fan is Started, or Fan StallsGeneration of OV (main circuit voltage) and stalling can occur if the fan is turning when it is started. The DCinjection braking is insufficient when starting.This can be prevented by slowing fan rotation by DC injection braking before starting the fan. Increase theconstant b2-03 (DC injection braking time (initial excitation) at start) setting. If Output Frequency Does Not Rise to Frequency ReferenceUse the following information if the output frequency does not rise to the frequency reference.The frequency reference is within the jump frequency range.When the jump frequency function is used, the output frequency does not change within the jump frequencyrange. Check to be sure that the Jump Frequency (constants d3-01 to d3-03) and Jump Frequency Width (con-stant d3-04) settings are suitable.The frequency reference upper limit has been reached.The output frequency upper limit is determined by the following formula:Maximum Output Frequency (E1-04) × Frequency Reference Upper Limit (d2-01) / 100Check to be sure that the constant E1-04 and d2-01 settings are suitable.
