Modes3- 7 Quick Programming ModeIn quick programming mode, the constants required for Inverter trial operation can be monitored and set.Constants can be changed from the setting displays. Use the Increment, Decrement, and Shift/RESET Keys tochange the frequency. The user constant will be written and the monitor display will be returned to when theDATA/ENTER Key is pressed after changing the setting.Refer to Chapter 5 User Constants for details on the constants displayed in quick programming mode.Example OperationsKey operations in quick programming mode are shown in the following figure.Fig 3.5 Operations in Quick Programming ModeQuick Programming ModeDRIVE QUICK VERIFYA.TUNEADVMode Selection DisplayMENUMonitor Display Setting DisplayControl method selectionReference selectionOperation method selectionStopping method selectionMotor protection selectionDeceleration stall selectionAO CH2 output gainAO CH1 output gainC1-01: Acceleration time 1C1-02: Deceleration time 1C6-01: CT/VT selectionC6-02: Carrier frequencyselectiond1-01: Frequency reference 1d1-02: Frequency reference 2d1-03: Frequency reference 3d1-04: Frequency reference 4d1-17: Jog frequency referenceE1-01: Input voltage settingE1-03: V/f pattern selectionE1-04: Max. output frequencyE1-05: Max. voltageE1-06: Base frequencyE1-09: Min. output frequencyE1-13: Base voltage (VBASE)E2-01: Motor rated currentDRIVE QUICK VERIFYA.TUNEADVESCDATAENTER DATAENTERDATAENTERDATAENTERDATAENTERESCESCESCESCESCESCESCESCESCESCESCESCESCDATAENTERDATAENTERDATAENTERDATAENTERESC