Digital Operation Display Functions and Levels5- 7* 1. 0 or 1 for flux vector control.* 2. The setting range for acceleration/deceleration times will depends on the setting for C1-10. When C1-10 is set to 0, the setting range for acceleration/deceleration times becomes 0.00 to 600.00 seconds.* 3. Only 1(VT) can be set for 200 V Class 110 kW as well as 400 V Class 220 kW and 300 kW Inverters.* 4. The factory settings depend on the capacity of the Inverter. The values for a 200 V Class Inverter of 0.4 kW are given.* 5. The upper limit of the setting range depends on the upper limit set in E1-04.* 6. When C6-01 = 1, the upper limit is 400.00 (d1 constants)/400.0(E1 constants).* 7. These are values for a 200 V Class Inverter. Values for a 400 V Class Inverter are double.* 8. The factory setting will change when the control method is changed. The V/f control factory settings are given.* 9. E1-13 is set to the same value as E1-05 by autotuning.* 10.The setting range is 10% to 200% of the Inverter's rated output current. The value for a 200 V Class Inverter of 0.4 kW is given.* 11.When using flux vector control, 0 to 2.* 12.The CH1 output can be adjusted when the H4-02 or H4-03 setting is displayed in Quick, Advanced, or Verify mode while the motor is stopped.The CH2 output can be adjusted when the H4-05 or H4-06 setting is displayed in quick, Advance, or Verify mode while the motor is stopped.For analog output, the value equivalent to 100% of output value of monitored item is multiplied by the gain setting and the set bias is added.* 13.When C6-01 = 0, the upper limit is 150.00 (d1 constants)/150.0(E1 constants).L3-04Stall pre-ventionselectionduring decel0: Disabled (Deceleration as set. Ifdeceleration time is too short, amain circuit overvoltage mayresult.)1: Enabled (Deceleration is stoppedwhen the main circuit voltageexceeds the overvoltage level.Deceleration restarts whenvoltage is returned.)2: Intelligent deceleration mode(Deceleration rate isautomatically adjusted so that inInverter can decelerate in theshortest possible time. Setdeceleration time is disregarded.)3: Enabled (with Braking ResistorUnit)When a braking option (BrakingResistor, Braking Resistor Unit,Braking Unit) is used, always set to0 or 3.0 to 3*11 1 No Q Q Q Q 492HCon-stantNumberName Description SettingRangeFactorySettingChangeduringOpera-tionControl Methods MEMOBUSRegis-terV/fV/fwithPGOpenLoopVec-torFluxVec-tor
