Modes3- 5 Switching ModesThe mode selection display will appear when the MENU Key is pressed from a monitor or setting display.Press the MENU Key from the mode selection display to switch between the modes.Press the DATA/ENTER Key from the mode selection key to monitor data and from a monitor display toaccess the setting display.Fig 3.3 Mode TransitionsIMPORTANTWhen running the Inverter after using Digital Operator, press the MENU Key to enter the drive mode (DRIVEindicator will flash) and then press the DATA/ENTER Key from the drive mode display to bring up the monitordisplay (DRIVE indicator will light). Run Commands can't be received from any other display. (Monitor displayin the drive mode will appear when the power is turned ON.)Drive ModeDRIVE QUICK VERIFYA.TUNEADVDRIVE QUICK VERIFYA.TUNEADVMENUMENUQuickProgramming ModeDRIVE QUICK VERIFYA.TUNEADVMENUAdvancedProgramming ModeDRIVE QUICK VERIFYA.TUNEADVMENUVerify ModeDRIVE QUICK VERIFYA.TUNEADVMENUAutotuningMode(Operation possible)DRIVE QUICK VERIFYA.TUNEADVDRIVE QUICK VERIFYA.TUNEADVDRIVE QUICK VERIFYA.TUNEADVDRIVE QUICK VERIFYA.TUNEADVDRIVE QUICK VERIFYA.TUNEADVPower ONDRIVE QUICK VERIFYA.TUNEADVDRIVE QUICK VERIFYA.TUNEADVDRIVE QUICK VERIFYA.TUNEADVMode Selection Displays Monitor Displays Setting DisplaysWhen returning from a settingdisplay, the rightmost digitof the monitor display willflash.If a user constant is changedthe number will be dislayed.ESCDATAENTERESCDATAENTERESC ESCDATAENTERDATAENTERESCDATAENTER DATAENTERDATAENTERDATAENTERESCDATAENTERESC ESCDATAENTERDATAENTERLit Flashing Not lit