Digital Operator Functions6-151Storing Inverter set values in the Digital Operator (READ)To store Inverter set values in the Digital Operator, make the settings using the following method. Set 03-02(Read permitted selection) to 1 (read permitted).An error may occur while saving to memory. If an error is displayed, press any key to cancel the error displayand return to the o3-01 display. Error displays and their meanings are shown below. (Refer to Chapter 7Errors when Using Digital Operator Copy Function.)Select READ PermittedPrevent overwriting the data stored in EEPROM in the Digital Operator by mistake. With o3-02 set to 0, if youset o3-01 to 1, and perform the write operation, PrE will be displayed on the Digital Operator, and the writeoperation will be stopped.Table 6.1 READ Function ProcedureStepNo. Digital Operator Display Explanation1 Press the Menu Key, and select advanced pro-gramming mode.2 Press the DATA/ENTER Key, and select theconstants monitor display.3 Display o3-01 (Copy Function Selection) usingthe Increment Key and Decrement Key.4 Press the DATA/ENTER Key, and select theconstants setting display.5 Change the set value to 1 using the IncrementKey.6 Set the changed data using the DATA/ENTERKey. The READ function will start.7If the READ function ends normally, End isdisplayed on the Digital Operator. Constant o3-01 is automatically reset to 0, and then the dis-play returns to o3-01.Error Display MeaningYou are attempting to set o3-01 to 1 while o3-02 is set to 0.Read data length mismatch or read data error.Tried to write constants to EEPROM on the Digital Operator, but unable to perform write operation.
