Version: 1.11 Function Reference 9722 FLEETSYNC# Using the Keypad• Enter the ID using [0] - [9].# Deleting the entered character• Press [A] - [#].The selected character is deleted.• Press and hold [A] - [#].All characters are deleted.4. Press the PTT switch to make a voice call.Press [Side 2]/ [!] to make a paging call.Press [S] to enter the Status Message. (Onlywhen the transceiver enters Status MessageEntry Mode using the PF Selcall + Status key.)(Refer to 22.3 Status Message Function.)22.2.2 Receiving a Selective CallThe transceiver enters the Reception Display Mode whenreceiving a Selective Call.The condition for the FleetSync ID to match is as follows.Table 22-4 Call TypeConditions to UnmuteNote: You must select “FleetSync” in the “Optional Signaling” inthe Channel Edit window or the GID Edit window.! Individual Call/ Group CallA user can respond to the party that appears on thedisplay by pressing the PTT switch or [Side 2]/ [!].The transceiver controls the mute function only anddoes not move to the Call Mode for the followingcondition.• The transceiver receives a call from the Fleetinhibited with the Interfleet configuration.• The receive ID is not registered in Data EncodeBlock ID.• The transceiver receives a call having the ID thatthe TX Inhibit function is enabled in the Selcall List.The display returns to normal when a key is pressed.The display returns to the last display after the AutoReset Timer expires if the Auto Reset Timer isconfigured.# When the ID is registered in the ID List(Individual Call):# When no ID is registered in the ID List(Individual Call):Call TypeConditions to UnmuteFleetfff: 100 - 399IDiiii: 1000 - 4999Individual Call Match MatchGroup Call Match Group ID matches.Fleet Call Match ALL IDSupervisor Call ALL Fleet MatchBroadcast Call ALL Fleet ALL IDTK-2180/ 3180TK-7180/ 8180TK-2180/ 3180TK-7180/ 8180TK-2180/ 3180TK-7180/ 8180