Kenwood TK-3180 Function Reference

Also see for TK-2180: Specifications Brochure & specs Instruction manual Instruction manual Service manual

Contents

Version: 1.11 Function Reference 9922 FLEETSYNC# When the ID is registered in the ID List(Broadcast Call):# When no ID is registered in the ID List(Broadcast Call):22.2.3 ID ListThe transceiver uses an individual FleetSync ID toperform communications if the FleetSync function isenabled. The FleetSync IDs to be called must be storedin the transceiver using KPG-89D. You can store up to100 FleetSync IDs.You can configure the following functions for the ID Listusing KPG-89D.Table 22-5 ID List Configuration! Configuration using KPG-89D• Configuring the ID List (Refer to FPRG 6.12.4 IDList tab.)22.3 Status Message FunctionThis function allows a user to send status messages(Status 10 - 99) by selecting the status messagenumbers. With this function enabled, the dispatcher cansend a message to the transceiver.22.3.1 Sending the Status MessageFollowing are the methods to send the Status Message.Table 22-6 How to Send the Status MessageID List OperationFleetConfigure the Fleet of the FleetSync ID. A user canselect ALL or the number between 100 and 349.You can call to all IDs when ALL is selected.IDConfigure the ID of the FleetSync ID. A user canselect ALL or the number between 1000 and4999.You can call to all IDs when ALL is selected.ID NameYou can configure the caller’s ID name. A usercan configure a maximum of 10 characters.When the caller’s ID Name is registered in the IDList, the ID Name appears on the display.TK-2180/ 3180TK-7180/ 8180TK-2180/ 3180TK-7180/ 8180TX InhibitEnable/disable the transmission to the receivingparty.When the transmision is inhibited, the status doesnot appear on the ID Selection window and a usercannot select the ID in Message Mode.When receiving a call from the ID, the caller’s IDName appears. In this case, the user cannotmake a call to the party even if the PTT switch orthe PF Ext. PTT (Voice) port is pressed.Status Message DescriptionMessage ModeThe transceiver enters Message Modewhen the PF SelCall + Status key or the PFStatus key is pressed to send a StatusMessage.A user can select the Status only bypressing the PF Status key to send theStatus Message.In this case, the receiving party is fixed tothe target Fleet/ID.PF Key DirectThe transceiver sends the Status Messageassigned to the PF Call 1 - Call 6 keys. Auser can assign statuses to No. 1 - 90 of theStatus List using the Key Assignmentfunction.In this case, the receiving party is fixed tothe target Fleet/ID.AUX INThe transceiver sends the Status Messagewhen the status of the AUX IN changes(High> Low or Low > High).In this case, the receiving party is fixed tothe target Fleet/ID.Turning theTransceiver ON/OFFThe transceiver sends the messageconfigured with the KPG-89D when thetransceiver is turned ON/OFF.In this case, the receiving party is fixed withthe target Fleet/ID.ID List Operation