23 SCAN132 Function Reference Version: 1.113. Press [C].The Priority Channel alternates in the followingorder.Normal > Priority 1 > Priority2 > Prirority1 & 2 >Normal ...4. Press [S].The selected channel is configured as thePriority Channel and the display returns to thechannel display.! Configuration using KPG-89D• Configuring the Priority 1 (Refer to FPRG 6.9.1Priority 1.)• Configuring the Priority 1 Zone-CH (Refer toFPRG 6.9.3 Priority 1 Zone-CH.)23.7.5 Priority 2/ Priority 2 Zone-CHThis function allows you to configure the high priorityZone/Channels. You can configure the followingfunctions for Priority 2.Table 23-5 Priority 2 OperationNote: You cannot configure the Priority 2 Zone - CH when“Selected” is selected in the Priority 2.! Configuration using KPG-89D• Configuring the Priority 2 (Refer to FPRG 6.9.2Priority 2.)• Configuring the Priority 2 Zone-CH (Refer toFPRG 6.9.4 Priority 2 Zone-CH.)23.7.6 Revert CH/GIDThis function allows you to configure the Zone-CH/GIDthat is transmitted when the PTT switch is pressed duringscan.You can configure the Revert CH/GID using KPG-89D.The Revert CH/GID function works as below.Table 23-6 Revert CH/GID OperationNote: The next Zone-CH/GID of the Last Called Zone-CH/GID orthe Last Used Zone-CH/GID is stored even if the transceiveris turned OFF. In this case, the Revert CH/GID is alsostored.• The last received CH/GID• The last used CH/GIDPriority 2 OperationNone No channel is configured as the Priority 2.Fixed You can use the Priority 2 Zone-CH configuredusing the KPG-89D as Priority 2.TK-2180/ 3180TK-7180/ 8180TK-2180/ 3180TK-7180/ 8180SelectedYou can configure the selected channel asPriority 2. You cannot select the Priority 2 usingthe KPG-89D.OperatorSelectableThe channel selected by a user is configured asPriority 2. The transceiver enters PriorityConfiguration Mode when the PF Scan key ispressed and held for more than 2 seconds.(Refer to 23.7.4 Priority 1/ Priority 1 Zone-CH.)Configuration During Scan While Scan PausesLast Called The last receivedZone-CH/GIDThe Zone-CH/GID onwhich the transceiverpauses scanLast Used The last used Zone-CH/GIDThe Zone-CH/GID onwhich the transceiverpauses scanSelected The last selected Zone-CH/GID beforeactivating scanSelected + TalkBackThe last selectedZone-CH/GID beforeactivating scanThe Zone-CH/GID onwhich the transceiverpauses scanPriority 1 Priority 1 ChannelPriority 1 +Talkback Priority 1 ChannelThe Zone-CH/GID onwhich the transceiverpauses scanPriority 2 Priority 2 ChannelPriority 2 +Talkback Priority 2 ChannelThe Zone-CH/GID onwhich the transceiverpauses scanPriority 2 Operation