Version: 1.11 Function Reference 315 PASSWORD FUNCTION5.2 Read AuthorizationPasswordThis password protects the configuration data and preventsthe operating frequencies from being read by unauthorizedpersons.You must enter the Read Authorization Password whenreading the configuration data from the transceiver usingKPG-89D. You cannot read the configuration data unlessthe correct Password is entered.You cannot start cloning the configuration data unless thecorrect Read Authorization Password is entered when thePassword is configured on the master transceiver.You can configure the Read Authorization Passwordusing KPG-89D You can configure the ReadAuthorization Password using any numbers between 0and 999999.You can enter the Read Authorization Password using theMic Keypad on the TK-7180/ 8180 or 12-keypad of theTK-2180/ 3180. You can also enter the password usingthe Selector or PF keys.! Transceiver Operation# Using Mic Key or 12/16-key keypad1. Press the Mic Keypad or keys on the 12/16-keykeypad and enter the password.2. Press [S] or [*] when you complete entering thepassword.When the correct password is entered, theMaster Transceiver Mode becomes ready forCloning.“CLONE LOCK” appears on the LCD again if thewrong password is entered and the transceiverreturns to Password Entry Mode.# Using the Selector or PF keys1. Select a number using the Selector or [ ]/[ ].The selected characters blink.2. Press [C] to confirm the entered characters.The entered character stops blinking andbecomes solid on the display.3. Repeat the steps 1 and 2 to enter the entirepassword.4. Press [S] or [*] after entering the password.When the correct password is entered, theMaster Transceiver Mode becomes ready forCloning.“CLONE LOCK” appears on the LCD again ifthe wrong password is entered and thetransceiver returns to Password Entry Mode.Note: Following keys can be used to enter the ReadAuthorization Password.Table 5-2 Key Operation! Configuration using KPG-89D• Configuring the Read Authorization Password(Refer to FPRG 6.7.1 Common-Page 1 tab - ReadAuthorization Password.)• Configuring the Clone function (Refer to FPRG6.7.2 Common-Page 2 tab - Clone.)Key Name OperationSelector/ [ ]/ [ ] Increase/decrease the number(0 - 9)[Side 1]/ [ ] The transceiver returns to the“CLONE LOCK” display.[S] Password authorization[A] Press: Delete a number.Hold: Delete all numbers.[B][C] Confirm the selected value and thenumber.[Side 2]/ [!][0] - [9] Enter the Digit number.[*] Password authorization[#] Press: Delete a number.Hold: Delete all numbers.PTT switch