Kenwood TK-3180 Function Reference

Also see for TK-2180: Specifications Brochure & specs Instruction manual Instruction manual Service manual

Contents

22 FLEETSYNC118 Function Reference Version: 1.1122.7.2 Caller ID StackThis function allows the transceiver to store the IDs of thecallers to the Stack Memory.The transceiver can store a maximum of three IDs. Thetransceiver can stack a maximum of 15 messages (StatusMessage and Short Message).The user can reply to the displayed Caller ID by pressingthe PTT switch or the PF Ext. PTT (Voice) port in CallerID Stack Mode.When the transceiver receives a call with FleetSync ID,the “ ” icon blinks to notify the user that the ID isstored. The user can enter Stack Mode to check thestored FleetSync IDs.The method to stack the IDs varies depending on theStores the latest received messages configuration.(Refer to 22.7.1 Stores the Latest Received Messages.)You can enable/disable the Caller ID Stack function usingKPG-89D.! Configuration using KPG-89D• Configuring the Caller ID Stack (Refer to FPRG6.12.2 General 2 tab - Caller ID Stack.)22.7.3 ID/Message Stack with TimeStampThis function allows the transceiver to stack Caller ID,Status Message, and Short Message with the receivedtime stamp.You can configure the received time whether or not to bestacked with the ID or message using KPG-89D.! Configuration using KPG-89D• Configuring the ID/Message Stack with TimeStamp function (Refer to FPRG 6.12.2 General 2tab - ID/ Message Stack with Time Stamp.)22.7.4 Message MemoryThis function allows the transceiver to stack Caller ID,Status Message, and Short Message even if thetransceiver is turned OFF.You can configure the message to be stored using KPG-89D.! Configuration using KPG-89D• Configuring the Message Memory (Refer to FPRG6.12.2 General 2 tab - Message Memory.)22.8 Timer FunctionThis function allows the transceiver’s time to be adjusted.A user can use this function to add the Time Stamp to thereceived information.Followings are the time adjustment functions.Table 22-19 Timer Function ListNote: This function may not be available for older versions oftransceivers. Refer to the PC Interface Protocol manual fordetails before you perform this function.22.9 Configuring the FleetSyncYou can configure the following functions relating toFleetSync using KPG-89D.• Own Fleet/ID• Unit ID Encode Block• Interfleet Call• FleetSync Baud Rate• Auto Reset Timer• FleetSync II• Manual Dialing• Group ID• GTC Count• Number of Retries• Transmit Busy Wait Time• Maximum ACK Wait Time• ACK Delay Time• Transmit Delay Time (Receive Capture)• Data Transmit Modulation Delay Time• Random Access (Contention)• Unit ID Serial Output• Selective Call Alert LED• Message Display Type• Alert Tone (Individual Call)• Alert Tone (Other Selective Calls)Timer Function FunctionRemote updatefunction of theinternal timer of thetransceiver over theairThis function allows a user to adjust thetime contained in the data according tothe clock Update request transmittedover the air from the Base Station.This function corrects the time of theinternal clock if the transceiver.The user can adjust the internal clock ofthe target transceiver in the samesystem by using the base station time asthe standard time .