22 FLEETSYNC112 Function Reference Version: 1.11! PTTThe transceiver sends the GPS data in conjunctionwith the PTT operation. You can select the timing tosend the GPS data from BOT/ EOT/ and Both.! StatusThe transceiver sends the GPS data in conjunctionwith the Status Message.! EmergencyThe transceiver sends the GPS data in conjunctionwith the Emergency transmission operation.Note:" The COM port of the transmitting party connected to theGPS receiver unit must be configured as “GPS”." The COM port of the receiving party connected to the GPSreceiver unit must be configured as “GPS” or “Data + GPSData Output”.! Transceiver Operation1. Press the PF Send the GPS Data key.The transceiver sends the GPS data.# When the GPS data is not sent properly sincethe receiving party is busy:“BUSY” appears on the display.22.6.1 Base Fleet/IDYou can configure the FleetSync ID to send the GPSdata.You can configure the Base Fleet/ID using KPG-89D.The FleetSync ID of the base station is normally used.! Configuration using KPG-89D• Configuring the Base Fleet (Refer to FPRG 6.12.6GPS tab - Base Fleet.)• Configuring the Base ID (Refer to FPRG 6.12.6GPS tab - Base ID.)22.6.2 GPS CombinationYou can configure the timing to send the GPS data.A user can add the GPS data when the transceiver is inPTT ID, Status, or Emergency Mode.You can configure the GPS Combination using KPG-89D.You can configure the following functions.! PTT IDThe transceiver sends the GPS data with the PTT ID(FleetSync) of the transmitting party. A user can addthe GPS data in conjunction with the PTT IDconfiguration (BOT, EOT, Both).Following are the ID to be sent and the GPS data.Table 22-14 ID and GPS dataFigure 22-1 Timing for the CPS Combination (PTT ID)TK-2180/ 3180TK-7180/ 8180TK-2180/ 3180TK-7180/ 8180GPSReportTimingPTT ID (Channel Edit)Off BOT EOT BothBOT - BOT +GPS EOTBOT +GPSEOTEOT - BOT EOT +GPSBOTEOT +GPSBoth (BOT) - BOT +GPSEOT +GPSBOT +GPSEOTBoth (EOT) - BOT +GPSEOT +GPSBOTEOT +GPSBoth - BOT +GPSEOT +GPSBOT +GPSEOT +GPSID GPS ID GPSPTTPTT ID + GPS