Version: 1.11 Function Reference 11 BASIC FUNCTION1.1 Functions and Panel Layout1.1.1 TK-2180/ 3180Figure 1-1 TK-2180/ 3180 Front ViewAntennaThis is the transceiver’s antenna.SelectorYou can configure the Zone and CH/GID using thisselector.Power Switch/Volume ControlYou can turn the transceiver ON by rotating thisswitch. The Volume control allows you to adjust thevolume level of the speaker.TX LED/BUSY LEDThese LEDs light when sending or receiving a signal(Refer to 3 DISPLAY.)Side 1 keyYou can activate the assigned function with this key.PTT switchPress this switch to transmit.MicrophoneThis is the transceiver’s microphone.Side 2 keyYou can activate the assigned function with this key.AUX keyYou can activate the assigned function with this key.SpeakerThe speaker emits the received audio signals andalert tones.LCD DisplayThe channel number and the transceiver’s statusappear on this display.PF keysPress any key to activate a function assigned to eachfunction key.KeypadPress any key to activate a function assigned to eachfunction key or enter the number.(12 Keypad models only)1.1.2 TK-7180/ 8180Figure 1-2 TK-7180/ 8180 Front ViewPower SwitchPress this switch to turn the transceiver ON and press itagain to turn it OFF.[ ]/[ ] keyThe Volume control allows you to adjust the volumelevel of the speaker.You can activate the assigned function with this key.[ ]/[ ] keyThe channel number and the transceiver’s statusappear on this display.You can activate the assigned function with this key.[Up]/[Down] keyYou can configure the Zone and CH/GID using thisselector.SpeakerThe speaker emits the received audio signals andalert tones.TX LED/BUSY LEDThese LEDs light when sending or receiving a signal.(Refer to 3 DISPLAY.)Microphone connectorYou can connect a microphone using this connector.J A B C