Version: 1.11 Function Reference 15128 VOX2. Adjust the VOX Gain Level using [B]/ [C], Selector,or [ ]/ [ ].3. Press [Side 1]/ [ ].The display returns to the Channel window.The VOX function is enabled.Note: The status of the VOX Gain Level is stored even if thetransceiver is turned OFF.! Configuration using KPG-89D• Configuring the VOX Gain Level (Refer to FPRG6.7.4 Conventional tab - VOX Gain Level.)• Assigning functions to the PF keys (Refer toFPRG 6.8 Key Assignment.)28.1.2 VOX Delay TimeIf the transceiver returns to the receive mode too quicklyafter a user stops speaking, his/ her final words may notbe transmitted. To avoid, this select an appropriate VOXdelay time that allows all of words to be transmittedwithout an overly long delay after the user stopsspeaking.The transceiver completes the VOX transmission whenno voice is spoken into the microphone during the VOXDelay Time.You can configure the VOX Delay Time using KPG-89D.Figure 28-1 VOX Delay Time! Configuration using KPG-89D• Configuring the VOX Delay Time (Refer to FPRG6.7.4 Conventional tab - VOX Delay Time.)28.1.3 TX Inhibit while ReceivingThis function is used to restrict the VOX transmissionwhile the transceiver is receiving signals.You can configure the TX Inhibit while Receiving functionusing KPG-89D.! Configuration using KPG-89D• Configuring the TX Inhibit while Receiving function(Refer to FPRG 6.7.4 Conventional tab - TXInhibit while Receiving.)28.1.4 Cancel OperationThis function allows the transceiver to disable the VOXfunction immediately when the PTT switch is pressed.A user can enable the VOX function by pressing andholding the PF VOX key again for more than 2 secondseven if the function is disabled with the PTT switch.When the PF VOX key is not configured, the user canenable the VOX function again by turning the transceiverOFF, then turning it ON again.You can configure the Cancel Operation using KPG-89D.Table 28-1 Cancel Operation! Configuration using KPG-89D• Configuring the Cancel Operation (Refer to FPRG6.7.4 Conventional tab - Cancel Operation.)• Assigning functions to the PF keys (Refer toFPRG 6.8 Key Assignment.)28.1.5 VOX Proceed ToneThis function allows the transceiver to emit a tonenotifying a user that the transmission using the VOXfunction has been enabled.You can enable/ disable the VOX Proceed Tone usingKPG-89D.TK-2180/ 3180TK-7180/ 8180TrnasmitReceiveVox Delay TimeWith Mic InputWithout Mic InputCancel Operation OperationCheck (Enable) The VOX function is disabled when thePTT switch is pressed.Uncheck (Disable) The VOX function will not be disabledeven if the PTT switch is pressed.