22 FLEETSYNC106 Function Reference Version: 1.11To enable this function, you must configure the StatusMessage to the AUX IN terminal.You can configure the Aux Input Status Message usingKPG-89D.! Configuration using KPG-89D• Configuring the AUX Input Status Message (Referto FPRG 6.12.7 Target tab - AUX Input StatusMessage 1 - 3.)22.3.8 AUX Output Status MessageThis function allows a user to alternate the Status of theAUX OUT terminal (High > Low or Low > High) whenreceiving the Status Message. The user can use thisfunction to remotely turn the external device On/Off.To enable this function, you must configure the StatusMessage to the AUX Out terminal.You can configure the AUX Output Status Message usingKPG-89D.! Configuration using KPG-89D• Configuring the AUX Output Status Message(Refer to FPRG 6.12.7 Target tab - AUX OutputStatus Message 1 - 3.)22.3.9 Power-on Status MessageThis function allows the transceiver to send the StatusMessage when the transceiver is turned ON.With this function enabled, the dispatcher acknowledgesthat the transceiver is turned ON. The transceiver sendsthe status message to the FleetSync ID configured withthe Target Fleet/ID (Status Message).You can configure the Power-on Status Message usingKPG-89D.! Configuration using KPG-89D• Configuring the Power-on Status Message (Referto FPRG 6.12.7 Target tab - Power-on StatusMessage.)22.3.10 Power-off Status MessageThis function allows a user to send the Status Messagewhen the transceiver is turned OFF.With this function enabled, the dispatcher acknowledgesthat the transceiver is turned OFF. The transceiver sendsthe status message to the FleetSync ID configured withthe Target Fleet/ID (Status Message).You can configure the Power-off Status Message usingKPG-89D.! Configuration using KPG-89D• Configuring the Power-off Status Message (Referto FPRG 6.12.7 Target tab - Power-off StatusMessage.)22.3.11 Status ListThe Status Message must be configured to thetransceiver prior to the transmission. A user can store amaximum of 90 Status Messages in the Status List.You can configure the Status List using KPG-89D. TheStatus List has the following functions.Table 22-10 Selective Call Type! Configuration using KPG-89D• Configuring the Status List (Refer to FPRG 6.12.5Status List tab.)22.3.12 Target Fleet/ID(Status Message)The Target Fleet/ID is the receiving party’s FleetSyncidentification to receive the following Status Messages.• Status Message transmission using the AUX INterminal• Power-on Status Message transmission• Power-off Status Message transmission• Status Message transmission using the PF Call 1 - 6keys• Status Message transmission after entering StatusMessage Mode by pressing the PF Status key.You can configure the Target FleetSync ID using KPG-89D. The FleetSync ID of the Base Station is normallyused.Call Type DescriptionStatus You can configure the Status Number. You canconfigure the number between 10 and 99.Status NameYou can configure the Status name. It is hard tounderstand the operation of the Status only withthe Status Number. In this case, you can put aname to the Status. You can configure amaximum of 16 characters to each Statusname.TX InhibitYou can enable/disable the transmission to thereceiving party.When the transmission is inhibited, the statusdoes not appear on the Status Selectionwindow. Therefore, a user cannot select theStatus in Message Mode if the transmission isinhibited.