22 FLEETSYNC114 Function Reference Version: 1.1122.6.5 GPS Report Interval Time(Ignition On)This function allows the transceiver to send the GPS dataat the configured intervals when “Auto” is selected in theGPS Report Mode.The GPS Report Interval (Ignition On) is the interval atwhich to send the GPS data while the vehicle is moving.You can configure the interval (to send the GPS datawhile the vehicle is moving) using KPG-89D.! Configuration using KPG-89D• Configuring the GPS Report Interval (Ignition On)(Refer to FPRG 6.12.6 GPS tab - GPS ReportInterval (Ignition On).)22.6.6 GPS Report Interval Time(Ignition Off)This function allows the transceiver to send the GPS dataat the configured intervals when “Auto” is selected in theGPS Report Mode.The GPS Report Interval (Ignition Off) is the interval tosend the GPS data while the vehicle is parked.You can configure the interval to send the GPS data whilethe vehicle is parked using KPG-89D.! Configuration using KPG-89D• Configuring the GPS Report Interval (Ignition Off)(Refer to FPRG 6.12.6 GPS tab - GPS ReportInterval (Ignition Off).)22.6.7 GPS Time MarkThis function allows the transceiver to configure theOffset duration to send the GPS data with UTC(Coordinated Universal Time).Each transceiver in the fleet transmits the GPS data withdifferent timing. This allows a user to avoid transmitcollision.You can configure the GPS Time Mark using KPG-89D.Note: The value must be smaller than the GPS Report Interval.! Configuration using KPG-89D• Configuring the GPS Time Mark (Refer to FPRG6.12.6 GPS tab - GPS Time Mark.)22.6.8 GPS Message TypeThis function allows the transceiver to change the lengthof the message to send the GPS data.When “Short” is selected, transmission time for the GPSdata can be reduced, compared with ones in the 80 and150-series.You can configure the GPS Message Type using KPG-89D.Table 22-17 GPS Message Type Operation! Configuration using KPG-89D• Configuring the GPS Message Type (Refer toFPRG 6.12.6 GPS tab - GPS Message Type.)22.6.9 GPS Report on Data Zone-CH/GIDThis function allows the transceiver to automaticallychange the Data Zone-CH/GID to send the GPS Report.The transceiver automatically changes the channel toData Zone-CH/GID to send the GPS Report. Thetransceiver returns to the previous Zone-CH/GID whenthe transceiver finishes transmitting the GPS report. Thisfunction allows the transceiver to send data using theselected Zone-Channel/Group ID.You can enable/disable this function using KPG-89D.! Configuration using KPG-89D• Configuring the PS Report on Data Zone-CH/GID(Refer to FPRG 6.12.6 GPS tab - GPS Report onData Zone-CH/GID.)GPS Message Type OperationFullThis message has the same format asthe 80/150-Series. The transmissionperiod is approximately 500 ms. Thetransceiver sends the GPS data, suchas $GPGGA, $GPRMC, and $GPGLL.ShortThe transmission period isapproximately 320 ms. The transceiversends the GPS data, such as $GPGLL.When the base station receives theShort GPS data, a part of data is outputas a blank even if the $GPGGA and$GPRMC are configured to PC serial-out.