Kenwood TK-3180 Function Reference

Also see for TK-2180: Specifications Brochure & specs Instruction manual Instruction manual Service manual

Contents

26 FUNCTION PORT148 Function Reference Version: 1.1126.2.2 CORThis port notifies a user that the transceiver is receiving aCarrier.This port becomes active when receiving a Carrier.Otherwise, this port is inactive.26.2.3 TORThis port notifies a user that the transceiver is receivingthe GID in a Trunking system and QT/ DQT is matched inConventional Groups.This port becomes active when receiving a call with GIDin a Trunking system. Otherwise, this port is inactive.This port becomes active when receiving a carrier on thechannel that the QT/DQT is configured in ConventionalGroups. Otherwise, this port is inactive.26.2.4 AUX AThe port output changes in conjunction with the PF AUXA port. A user can control an external device connectedto the PF AUX A port.26.2.5 AUX BThe port output changes in conjunction with the PF AUXB port. A user can control an external device connectedto the PF AUX B port.26.2.6 System BusyThis port becomes active when no repeater is available ina Trunking system. Otherwise, this port is inactive.26.2.7 PTT OutThis port notifies a user that the PTT switch is pressed.You can use this function when an optional board or anexternal device is connected to the transceiver.This port becomes active when the PTT switch ispressed. Otherwise, this port is inactive.26.2.8 Channel BusyThis port notifies a user that the remote control requestfrom the external device is rejected.This port becomes active in the following conditions.Table 26-5 Conditions for the Channel Busy Port toBecome Active26.2.9 COR or Channel BusyThis port becomes active when the COR port or ChannelBusy port is active. When neither of ports is disabled, thisport becomes inactive.You can use this port to connect the KPG-2A or KDS-100to the transceiver. With this port, you can restrict thetransmission request to the KPG-2A or KDS-100 whenyou do not want the transceiver to be controlled with anexternal device.26.2.10 TOR or Channel BusyThis port becomes active when the TOR port or ChannelBusy port is active. When either of the ports is disabled,this port becomes inactive.26.2.11 TXSThis port notifies a user that the transceiver istransmitting.This port becomes active when the transceiver istransmitting. Otherwise, this port is inactive.26.2.12 AUX Out Status Message 1 - 3This port is used to change the status of the transceiverwhen it receives the FleetSync Status Message.This port switches the Status of the AUX Out port (High >Low or Low > High) when the received Status Messagematches the Status number configured to the port.You can configure 2 Statuses (High > Low or Low > High)to each port since these ports are AUX Output ports.This port is normally used to remotely control thetransceiver by connecting an external device to the AUXOut.Mode StatusTransmissionAll transmissions (including automatictransmission and the transmission using thePTT switch)Emergency Emergency Mode