4 SOUND26 Function Reference Version: 1.11! TK-7180/ 8180# Selecting “Preset” in Minimum Volume TypeThe volume of the transceiver is automaticallyconfigured to the Minimum Volume level when thetransceiver is turned ON even if the volume levelwas completely turned down and the transceiverwas turned OFF.# Selecting “Lowest Limit” in Minimum VolumeType,This function allows you to limit the MinimumVolume level when the Volume control is turned toits lowest level.This prevents the user from missing calls even ifthe Volume control has been turned down. Thevolume increases from the Minimum Volume Levelwhen turning the Volume control clockwise. Thetransceiver mutes completely when turning theVolume control to the full counterclockwiseposition if the Minimum Volume is not configured.! Configuration using KPG-89D• Configuring the Minimum Volume (Refer to FPRG6.7.2 Common-Page 2 tab - Minimum Volume.)• Configuring the Minimum Volume Type (Refer toFPRG 6.7.2 Common-Page 2 tab - MinimumVolume Type.)4.3 Maximum Volume(TK-2180/ 3180 only)This function allows you to limit the maximum volumelevel when the Volume control is turned to fully clockwise.This prevents a user from excessive volume whenwearing the headset.You can configure this function using KPG-89D.! Configuration using KPG-89D• Configuring the Maximum Volume (Refer to FPRG6.7.2 Common-Page 2 tab - Maximum Volume.)4.4 Tone Volume OffsetThis function allows you to configure the offset level fromthe volume level. You can use this function whenadjusting the volume level of the tone.You can configure this function using KPG-89D.! Configuration using KPG-89D• Configuring the Tone Volume Offset (Refer toFPRG 6.7.2 Common-Page 2 tab - Tone VolumeOffset.)4.5 Tone VolumeYou can configure the volume level of various tones usingKPG-89D.You can use this function when adjusting the volume levelof the tone.You can configure the Tone Volume for each tone usingKPG-89D. You can configure the volume of the followingtones.Table 4-7 Available Tone Volume! Configuration using KPG-89D• Configuring the Power-on Tone (Refer to FPRG6.7.2 Common-Page 2 tab - Power-on Tone.)• Configuring Control Tones (Refer to FPRG 6.7.2Common-Page 2 tab - Control Tone.)• Configuring Warning Tones (Refer to FPRG 6.7.2Common-Page 2 tab - Warning Tone.)• Configuring Alert Tones (Refer to FPRG 6.7.2Common-Page 2 tab - Alert Tone.)• Configuring Sidetones (Refer to FPRG 6.7.2Common-Page 2 tab - Sidetone.)• Configuring Locator Tones (Refer to FPRG 6.7.2Common-Page 2 tab - Locator Tone.)Tone Volume OperationCurrent The current tone operates in conjunctionwith the Tone Volume.1 - 31The transceiver emits tones with the fixedtone volume. Higher values result in greatervolume.Off The transceiver does not emit any tones.SelectableThe tone volume changes in conjunctionwith the PF Fixed Volume key. (Refer to4.6 Selectable Tone Level.)