Kenwood TK-3180 Function Reference

Also see for TK-2180: Specifications Brochure & specs Instruction manual Instruction manual Service manual

Contents

Version: 1.11 Function Reference 5115 TRANSPONDThis function allows you to send the Acknowledge signalwhen receiving a call. The transceiver transmits theTranspond Tone when the Acknowledge is transmitted.The dispatcher can also confirm that the transceiver iswithin the communication range, or outside of thecommunication range.The Transpond operation varies between the OptionalSignaling call and the LTR ID call.15.1 Transpond Using theOptional SignalingThe transceiver transmits the acknowledge signal to theDispatcher after receiving the Individual Call with 2-toneor DTMF, or DTMF Stun code.Note:" Transpond does not work with Group calls." The Transpond function is canceled when changing the channelwhile the transceiver is in Transpond Standby Mode." When the Clear to Transpond function is enabled, theTranspond is not transmitted while the channel is being used.(Refer to 15.3.1 Clear to Transpond.)15.2 Transpond Using the LTR IDThis function allows the transceiver to transmit anAcknowledge signal to the dispatcher after receiving acall with the LTR ID. The transceiver performs theTranspond function after the Transpond Delay Timeexpires. (Refer to 15.4.1 Transpond Delay Time.)Note:" When the Transpond ID is received during scan, the transceiverperforms the Transpond function after the Transpond DelayTimer expires. The transceiver resumes scan after the DwellTimer expires. If the Dropout Delay Timer is shorter than theTranspond Delay Time, the transceiver performs the Transpondfunction after the Dropout Delay Time expires." The Transpond operation is canceled when changing the Zoneor GID during the Transpond Delay Time." While the TX Inhibit function is activated, the transceiver will notTranspond. (Refer to 17.1.19 TX Inhibit (Block IDs).)15.3 Conventional Group15.3.1 Clear to TranspondThis function allows you to wait for performing theTranspond function until the channel becomes available.You can enable/disable this function using KPG-89D.You can configure this function to 2-tone and DTMF.! Configuration using KPG-89D• Configuring the Clear to Transpond (2-tone)(Refer to FPRG 6.11.1 Decode tab - Clear toTranspond.)• Configuring the Clear to Transpond (DTMF)(Refer to FPRG 6.10.2 Decode tab - Clear toTranspond.)15.4 Trunking SystemThis function allows the transceiver to transmit anacknowledge signal to the dispatcher after receiving a callwith the LTR ID. The transceiver performs the Transpondfunction after the Transpond Delay Time expires.You can enable/disable this function for each Group IDusing KPG-89D.! Configuration using KPG-89D• Configuring the Transpond function (Refer toFPRG 6.6.12 Transpond.)15.4.1 Transpond Delay TimeThe Transpond Delay Time is the delay time between thetime when the transceiver receives an Group ID and thetime when it transmits the Transpond signal.If the Dropout Delay Time is shorter than the TranspondDelay Time, the transceiver performs the Transpondfunction after the Dropout Delay Timer expires. (Refer to23.7.7 Dropout Delay Time.)You can configure the Transpond Delay Time using KPG-89D.! Configuration using KPG-89D• Configuring the Transpond Delay Time (Refer toFPRG 6.7.5 Trunking tab - Transpond DelayTime.)