Cabletron Systems CSX1200 User Manual

Also see for CyberSWITCH CSX1000: User guide Quick start

Contents

Workgroup Remote Access Switch 107CONFIGURING B ASIC IP ROUTINGIP Network InterfacesIf IP RIP is enabled, enter the following additional information:h. IP RIP send controli. IP RIP respond controlj. IP RIP receive controlk. IP RIP v2 authentication controll. IP RIP v2 authentication key (required only if the IP RIP v2 authentication control has beenconfigured with a value other than “No Authentication”6. For a WAN IP UnNumbered network interface enter the following information:a. MTU size7. For a system configured in the IP host operating mode, the following information will berequired for a network interface:a. IP address assigned to this interfaceb. subnet maskc. MTU sized. transmit broadcast addressIf IP RIP is enabled, enter the following additional information:e. IP RIP receive controlf. IP RIP respond controlg. IP RIP v2 authentication controlh. IP RIP v2 authentication key (required only if the IP RIP v2 authentication control has beenconfigured with a value other than “No Authentication”U SING M ANAGE M ODE C OMMANDSipnetifThis command displays the current IP network interface configuration.NETWORK INTERFACE C ONFIGURATION ELEMENTSTYPESpecifies the interface type: LAN, WAN, WAN Direct Host, WAN RLAN (Remote LAN), or WANUnNumbered. For the LAN, you may configure both primary and secondary interfaces. Theprimary interface specifies how RIP, IP filters, and proxy ARP operate on all LAN networkinterfaces for a specified LAN port.NAMEUser-defined. An interface name is a 1 to 16 character user-defined string that identifies theinterface to the system administrator. Each interface (LAN or WAN) must have a unique name.IP ADDRESSThe IP address (using dotted decimal notation) assigned to this interface. The IP address applies toLAN type interfaces and WAN type interfaces only. Each LAN interface must be configured witha unique IP address.