Cabletron Systems CSX1200 User Manual

Also see for CyberSWITCH CSX1000: User guide Quick start

Contents

USER’S GUIDE44 CyberSWITCHElectrical Characteristics AC Power Input:Voltage: 100-125 VAC/200-240 VACFrequency: 50/60 HzFuse: 1.0/0.5 amps, 250VPower: 50 watts maximumNote: Main circuit card fuse labeled F1 is rated at 0.5A 63V. This fuse protects the 12VAUI circuitry on the main board. This fuse is a factory serviceable item only.Regulatory ComplianceMeets or exceeds the following:Safety: UL 1950, CSA C22.2 No. 950, EN 60950, IEC 950,and 72/23/EECEMI: FCC Part 15, EN 55022, CSA 108.8, EN 50082-1,VCCI V-3, and 89/336/EECCABLING INFORMATIONThe following sections provide cabling information for the following accesses:• LAN• Back-to-Back• WAN• Administration ConsoleLAN A CCESSThe CyberSWITCH’s internal Ethernet interface provides direct support for a single Ethernet (or802.3) LAN, which allows remote routing of LAN data. Since the system is a factory-customizedproduct, there is no need to install specific adapter boards. Access to the LAN is very simple viaconnectors on the system’s back panel. Connections to the Ethernet LAN may be made eitherthrough the 15-pin AUI connector (10Base5) or the RJ45 connector (10Base-T). A 10Base2connection is also possible with the AUI connector by using a 10Base2 conversion MAU. Once aparticular connection is made to either the AUI or the 10Base-T, the system’s LAN interfacehardware activates that connection.For coax connections, a Media Access Unit (MAU) is required for the LAN port on theCyberSWITCH. This is not normally included with our product. To reiterate, the options forconnection are:1. 10Base-T (Twisted Wire Ethernet) RJ-452. 10Base5 (Thick Ethernet) AUI External MAU required3. 10Base2 (Thick Ethernet) AUI 10Base2 conversion MAU requiredAn AUI cable can be used between the Ethernet LAN adapter and the MAU. The AUI cables (aswell as the MAU) are not shipped with our product.