| 
USER’S GUIDE456 CyberSWITCH[IP] WAN (Direct Host) Interface , invalid associated LAN interface interface name>The WAN (Direct Host) type interface could not come up; the associated LAN network interface,specified by configuration, was not found. Use CFGEDIT to delete old WAN (Direct Host)interface. Check for associated LAN interface, and add if necessary. Then add back the WAN(Direct Host) interface.[IP] WAN (Direct Host) Interface for network on LAN port initialized successfullyThis message is posted when WAN (Direct Host) interface for the indicated network is initializedsuccessfully.[IPCP] Invalid pre-configured IP address for , ignoredThere is a configured IP address for the remote device in the Device Table, but the IP address doesnot belong to any configured WAN interfaces. Check the configuration. You will most likely needto add another WAN interface.[IPCP] IP Address Pool - Out of IP addressesIPCP needed to allocate an IP address from the IP address pool, but there were no IP addressesavailable in the IP address pool. You may need to add more IP addresses to the pool.[IPCP] Option Negotiation Failure, Non-Convergence detectedIPCP is terminated because an agreement could not be reached on the details of protocol. Refer tothe specific documentation for the device in question to determine if it is configured correctly.Then, contact your Distributor or Customer Support.[IPCP] Remote device does not negotiate IP addressPlease configure IP address for the device The IP address for the remote device is either improperly configured, or not configured at all.Check configuration and adjust.[IPFILT] Filter “abcd” does not exist, ignored by application point “xyz”This particular error message detects that an attempt has been made to apply a non-existent filter.In theory, this can only happen if someone manually modifies a configuration file (other thanthrough CFGEDIT or Manage Mode).[IP Host] Call Dropped: ID Response was not received from remoteThe system did not receive a valid identification exchange from the remote IP Host. The system hasrejected the incoming call. Refer to the Quick Start for proper setup of your particular device.[IP Host] Call Dropped: XID was not received from remoteThe system did not receive a valid identification exchange from the remote IP Host. The system hasrejected the incoming call. Refer to the Quick Start.[IP Host] Security Rejection - Digit string wrong lengthThe system did not receive a valid identification exchange from the remote IP Host. TheIdentification digit string from the remote device was not of an appropriate length. This string mustbe a 24 character string of ASCII digits (0-9), which is blank padded. The system has rejected theincoming call. |
