| 
Workgroup Remote Access Switch 445SYSTEM M ESSAGESSystem Message SummaryDM upgrade success. Board=, Modem=The system has successfully updated the firmware of the specified modem on the Digital Modemcard.DM: TimeSlot driver circuit id already in use on CREATEDM: No TimeSlot driver circuits available for CREATEDM: TimeSlot driver circuit id not in use on REMOVEDM: TimeSlot driver circuit id not found on REMOVEThere were problems related to the Digital Modem’s use of the TDM bus. Contact your Distributoror Customer Support.Downloading Bootstrap to DM card in slot Informational message stating that the system is attempting to initialize a Digital Modem card.Watch for subsequent log messages to ensure the initialization is successful.Downloading DM card in slot with operational softwareInformational message displayed during a successful initialization. Watch for subsequent logmessages to ensure the initialization is successful.Downloading WAN card in slot with operational softwareInformational message during a successful system initialization. The status of the downloadprocess for WAN card in slot is identified. This should be reported after the “Bootstrapcame alive...” message for a given adapter.DSL test failed to establish Layer 1, port=During power up, all WAN lines undergo a test to see if Layer 1 can be established. This messageindicates a test failure. Check the wiring. If correct, contact your phone company.Duplicate Calling Line ID detected for devices and This message is logged at system initialization if any devices are found to share duplicate Callingline Ids, and have no other authentication method. This problem should be corrected by addingadditional authentication method(s) to the necessary device(s).Each mandatory connection uses xx bytesThere is not enough memory available to accommodate the system’s total capacity load. Thisinformational message identifies how much memory is needed to add an additional mandatoryconnection.Each optional connection uses xx bytesThere is not enough memory available to accommodate the system’s total capacity load. Thisinformational message identifies how much memory is needed to add an additional optionalconnection.ECP negotiation failed to convergeVerify compatible encryption parameters on each side of the link.EDRV transmit error An error was returned upon the software’s request to transmit a data frame. Contact yourDistributor or Customer Support. |
