Cabletron Systems CSX1200 User Manual

Also see for CyberSWITCH CSX1000: User guide Quick start

Contents

HARDWARE INSTALLATIONP RE -INSTALLATION R EQUIREMENTSBefore you begin the installation process, be sure to:• Choose a suitable setup locationMake sure the location is dry, ventilated, dust free, static free, and free from corrosivechemicals• Verify system power requirementsThe appropriate standard power cord is supplied with the system. The power supply willaccept any input voltage from 85 to 264 volts without the need to select a voltage range.• Verify cabling requirementsThe cabling shipped with your system should include:• BRI/PRI/LAN patch cables, 5 meters each.• RS232 cable, 1.8 meters. This is for the console port. This cable is a 9-pin female to 9-pinfemale null modem cable. Jack screws are included.Note: The BRI/PRI/LAN cables are straight-through CAT5 patch cables. The quantityshipped varies, based on device requirements. These cables are not distinguishedfrom each other in the carton.We provide a cable for the 10Base-T port since it is typically used for the LAN connection.However, if you plan to use the AUI port instead, you must provide your own cabling andMAU for this connection. If you need additional cabling (other than what was shipped),contact your distributor.• Verify administration console requirementsIn order to install system software, you must have a PC or workstation available. (One isnot provided with the system.) This PC or workstation will connect up to the system viathe RS232 port. You will also need a communications package that supports terminalemulation software (in order to transfer software to the system).For details on software installation, refer to the Software Installation chapter.Voltage Range Current and Frequency85-264 V .6 A47-63 Hz