Cabletron Systems CSX1200 User Manual

Also see for CyberSWITCH CSX1000: User guide Quick start

Contents

Workgroup Remote Access Switch 537S YSTEM COMMANDSIP Routing CommandsLMI Error StateCurrent LMI alarm condition. When this item is TRUE, the LMI alarm is on, and all associatedPVCs are unavailable. When this item is FALSE, the alarm condition is clear.LMI DLCIDLCI value associated with the LMI link. This is the DLCI value contained in all LMI messagesand varies according to the LMI format in effect. Note that this is not user configurable.# LMI Frames ReceivedNumber of frames received on the LMI link.# Good LMI Frames ReceivedThe number of valid LMI frames received during the last N391 period. This count is reset aftereach N391 events. (The N391 parameter is the configured Full Status Enquiry Polling Count.)# Errored LMI Frames ReceivedNumber of invalid or errored LMI frames received during the last N391 period. This count isreset when N392 is reached. (The N391 parameter is the configured Full Status Enquiry PollingCount, and the N392 parameter is the configured Error Threshold Count.)Unknown DLCI listList of all unknown DLCIs which have been referenced by either STATUS messages or CLLMmessages. This information is helpful in finding and solving problems on the Frame RelayAccess. In particular, the DLCI list is maintained within the code to identify all DLCIs for whichthe network has knowledge, but which are not currently configured. This list is updated whenunknown DLCIs are noted through the LMI FULL REPORT STATUS messages, or throughCLLM messages.fr dbg level Displays or sets the current debug level for frame relay. If the level parameter is not specified,then the current debug level is displayed. The debug level corresponds to an internal variablethat controls how much information is written to the system log as frame relay events occur.Possible settings for this parameter are 0 through 2, with 0 being the least informative and 2being the most informative.fr congDisplays the congestion control information for the last 32 Rate Measurement Intervals for thecurrently selected access and DLCI. It is provided mainly for debug support of frame relayPVCs in order to monitor PVC usage.IP R OUTING C OMMANDSIn order to use the following commands, you must properly configure and initialize IP routingoperating mode. In addition, you must enable RIP to use the ip rip commands.The following commands are used to display IP routing information:ip addrpoolDisplays the current IP address pool. There are three fields displayed: address, origin, and in use:• address: lists the IP address in the pool