| 
USER’S GUIDE532 CyberSWITCH name> is not callableEach PPP device in the device database can have one or two phone numbers at which theycan be called. This message is displayed if the device has no phone number specified.Re-enter the name, or to cancelThe device name must be re-entered.Unable to prompt for device name at this timeIndicates that thecall command would prompt you for a device name, but the necessaryresources are not available. The recommended actions are as follows:1. If possible, enter the device name on the command line.2. If the device name cannot be entered from the command line (for example, the devicename contains command line delimiters of a space, a comma, a colon, or a tab), the usercan wait for a few minutes and see if any resources become available.3. If actions 1 and 2 are ineffective, this may indicate an internal problem in the System,please inform your service representative of the occurrence.call peer number> [data rate] [device] [bearer]Initiates a call to a peer at the given number. Entering the data rate, device, and bearer isoptional. We describe each of the optional fields below.data rateThe default data rate value for HDLC calls is 56Kbps. The default data rate for digital modemcalls is Auto.deviceThe valid values are:• HDLC: used for normal HDLC-ISDN calls• DM: used for Digital Modem calls.bearerThis field applies only to Digital Modem calls. The valid values are:• SPEECH (the default if no bearer type is specified)• 3.1KHZThecall peer command allows you to make a connection with another device. For example,to call a site with the configured phone number of 13135552222 and a data rate of 64Kbps, youwould entercall peer 13135552222 64.To use this command for troubleshooting, you must enable the Call Trace feature to captureany connect and disconnect messages that are generated by issuing thecall peer command.To do this:1. Erase the current report log by enteringer at the system prompt.2. Enable the Call Trace feature by enteringtrace on at the system prompt.3. Issue thecall peer number> [data rate] command. |
