Cabletron Systems CSX1200 User Manual

Also see for CyberSWITCH CSX1000: User guide Quick start

Contents

Workgroup Remote Access Switch 359S YSTEM VERIFICATIONVerifying IP Host Mode is OperationalV ERIFYING IP H OST MODE IS OPERATIONALThe follow sections provide methods of verifying that the IP Host Mode has properly initializedand that the feature is operational.VERIFYING IP HOST IS I NITIALIZEDIf you have configured the IP feature in the Host mode, follow the steps below to verify that it hasinitialized properly.1. Determine if IP Host has been initialized by viewing the system messages. To view themessages, enter the following command:dr 2. Look for the following IP message among the system messages:[IP] IP Host is initialized successfully3. For the IP Interface that has been configured, the following interface initialization messageshould be displayed among the system messages:[IP] Network initialized successfully on ddd.ddd.ddd.dddNote: Other messages may also be displayed with the IP router initialization messages.If you see these IP host initialization messages, then the IP host is operational.If these IP host initialization messages are NOT displayed, refer to IP Host Initialization of theProblem Diagnosis chapter.VERIFYING IP HOST M ODE IS O PERATIONALThe following two sections provide a method to verify that the IP Host mode feature is operational.To verify that IP Host mode feature is properly operational, a remote IP Host must be operationaland available to initiate WAN connections via a remote bridge device. Also, a local IP host must beconnected to the local LAN port on the CyberSWITCH.Each section below uses example entries to verify IP Host mode operation. IP addresses are specificto the examples. Substitute the IP addresses of your network when you perform the IP Host modefeature verification steps. Each section also uses theip ping command. Theip ping commandsends a packet to a specified host, waits for a response, and reports success or failure. Substitute theequivalent command on your IP host.V ERIFYING IP H OST MODE O PERATION OVER A LAN CONNECTIONThe steps to verify the operation of IP Host mode feature over a LAN connection are:1. Determine if the CyberSWITCH can access the local IP host. Type:ip ping 100.0.0.2