Workgroup Remote Access Switch 93C ONFIGURING RESOURCES AND L INESLinesd. parity valuee. flow control typef. mode:• Autosense (default): can be either terminal or PPP-async. Requires user interaction(four carriage returns) to get to terminal mode.• Term: terminal mode only. Login prompt automatically sent to remote console.C ONFIGURING A LINE FOR A PRI RESOURCE1. Enter the line name.2. Select the line’s slot and port combination.3. Select following line characteristics:• framing type• line coding type• T1 signaling methodIf you are unsure of your line's characteristics, try the following defaults:4. Select the correct T1 line build out value (US only). If you are using an external CSU, specify ashort haul build out (line length in meters). If you do not have an external CSU, specify a longhaul build out (decibel attenuation value from Telco).5. A data link is assigned to the line upon completion of the line configuration. Add more datalinks or modify the existing data link.a. Only if you plan on using X.25 over the D-Channel on this line, answer yes to the followingprompt:b. Assign a TEI Negotiation value of 0.Note: You must delete the data link for a Robbed Bit line.U SING M ANAGE M ODE C OMMANDSlineDisplays the current line configuration.datalinkDisplay the current data link configuration.Characteristic PRI/T1 lines E1 lineFraming type ESF Multiframe CRCLine coding type B8ZS N/ASignaling Method Common_Channel N/AWill this Data Link support X.25 communications (Y/N)? [default N]
