USER’S GUIDE86 CyberSWITCHD EFAULT C ONFIGURATIONYour CyberSWITCH is shipped with a default set of configuration files that are preinstalled. Theseconfiguration files provide basic functions which will allow you to perform initial installation testswith no additional configuration.The default configuration files will allow IP access over both the LAN and the WAN interfaces. Thiswill allow you to PING, TELNET and TFTP into the CyberSWITCH. For example, these defaultswill allow you to TELNET into the system and log in. Once logged in, you may execute any of theconsole commands available.Once you perform initial testing, you must set the proper IP addresses. Most of these defaults willbe country-independent. As with any set of defaults, there may be specific cases where these arenot correct and must be changed before the units are connected to the networks.Default Configuration Summary:• Bridging Disabled• IP Routing Enabled• IP LAN Interface with IP address 1.1.1.1• Device Level Security• CHAP enabled• USER1 configured as PPP device (USER1 as secret) UnNumbered IP• USER2 configured as PPP device (USER2 as secret) IP address 002.002.002.003• Single BRI line and resource configured on country-specific basis (for BRI platforms):JAPAN: Point-Multipoint Automatic TEISwitch type: NTT INSEUROPE: Point-Multipoint Automatic TEISwitch type: NET3(default country code: Norway)U.S.: Point-to-point linesBRI_5ESS• Single PRI line and resource configured on country-specific basis (for PRI platforms):JAPAN: Switch type: NTT INSEUROPE: Switch type: NET5(default country code: Norway)U.S.: 4ESS• Single data link (with no SPID) configured (for BRI platforms)• IP WAN Interface with IP address 2.2.2.2• TELNET and TFTP enabled• TFTP allows all files to be changed by ADMINU SING THE NETWORK WORKSHEETSPlease take the time to fill out the requirements worksheets located in System Worksheets. Therequirements worksheets are:• Network Topology Worksheet• System Details Worksheet• System Device List Worksheet(s)• Bridging/Routing Worksheets