| 
Workgroup Remote Access Switch 385PROBLEM DIAGNOSISBridge InitializationB RIDGE INITIALIZATIONProblem:The system does not display the following bridge initialization messages:LAN Port #> is now in the LISTENING stateLAN Port #> is now in the LEARNING stateLAN Port #> is now in the FORWARDING stateAction:1. Make sure the LAN Adapter has initialized correctly.2. Check the configuration to verify the bridge is enabled.IP R OUTING INITIALIZATIONProblem:The system does not display the expected IP routing initialization messages.Action:1. If you did not see the following IP message:[IP] IP router is initialized successfullyCheck the configuration to verify that IP routing is enabled.2. The failure to see the following IP message for each IP interface:[IP] Network initialized successfully on ddd.ddd.ddd.dddindicates that you may have either not configured a needed interface or have incorrectlyconfigured an interface. Check the system’s IP network interface configuration using theipnetif command (a Manage Mode command). If there is a problem with the configuration,use theCFGEDIT to make corrections.WAN L INE A VAILABILITYProblem:The system does not display the WAN line availability messages. Instead, the system displays thefollowing message after thestatus console command is issued:Line (slot #, port #) downAction:1. Verify that the line is correctly attached to the proper system resource and port.2. If the line was correctly attached in action 1, try restarting the system.3. If actions 1 and 2 fail to correct the problem, call your phone company (carrier) to check thestatus of the line. |
