Workgroup Remote Access Switch 457SYSTEM M ESSAGESSystem Message Summary[IP Host] Security Rejection - Invalid Security ID The system has received an IP Host Id, , from a remote device that is not configured inthe Device List. The system has rejected the incoming call. Verify that the IP Host ID in the DeviceList information is identical to the IP Host Id configured in the remote device.[IP Host] Security Rejection - Security ID cannot be validated with Authentication ServerThe System authentication type is configured to obtain device information off-node, for examplefrom a RADIUS server; however, such transactions are not yet supported when IP Host ID Securityis enabled.[IP RIP] All network interfaces usedAll RIP interface data structures are in use. No RIP information will be sent to any additionalinterfaces. Contact your Distributor or Customer Support.[IP RIP] Buffers allocatedThe RIP successfully allocated the UDP buffers needed to transmit RIP packets.[IP RIP] Initialization failed, unable to allocate buffersThe RIP initialization was not completed. The machine contains insufficient memory to allocate theUDP buffers needed to transmit RIP packets. Contact your Distributor or Customer Support.[IP RIP] RIP Protocol Initialization successfulThe RIP protocol was successfully initialized.[IP RIP] Route Maintenance Registration FailedThe IP RIP protocol was unable to register with the IP routing table notification system. Anydynamic changes of the routing table configuration will not be reflected in the RIP packets sent toother routes. contact your Distributor or Customer Support.[IP RIP] Send queue fullThe RIP transmission queue has become full. This is not a normal occurrence. The machine shouldbe restarted. If this message is displayed again after the machine has been restarted, contact yourDistributor or Customer Support.[IP RIP] Shutdown completeThe RIP protocol was successfully shutdown via Dynamic Management. No RIP routinginformation will be transmitted or received. Any routes learned via RIP will soon expire.[IP RIP] Unable to add host route A failed attempt was made to add the host route to the IP RIP routing table. The routing table canhave approximately 300 routing entries, and at this time, the routing table is full. The host route willnot be broadcast via RIP packets and therefore other routers will not be able to learn the route tothis device. You can use the packet capture commands to try to determine if a device is advertisingan unusual number of routes. If you are unable to track down the problem, contact your Distributoror Customer Support.[IP RIP] Unable to add route, routing table fullThe IP RIP routing table is currently full, no new routes can be added. The routing table can haveapproximately 300 routing entries, and at this time, the routing table is full. This could result inpossible unreachable destinations. You can use the packet capture commands to try to determineif a device is advertising an unusual number of routes. If you are unable to track down the problem,contact your Distributor or Customer Support.
