| 
Workgroup Remote Access Switch 429SYSTEM M ESSAGESSystem Message Summary1 port LAN Adapter, operating in remote mode onlyThis is an initialization message. It identifies the Ethernet adapter type (Ethernet-1), and operatingmode. Remote bridging is supported.2 port LAN Adapter, operating in local and remote modeThis is an initialization message. It identifies the Ethernet adapter type (Ethernet-2), and operatingmode. Both local and remote bridging are supported.aarp found duplicate AppleTalk address @ The address resolution protocol found duplicate AppleTalk addresses for this AppleTalk network.Check the configuration for the AppleTalk ports’ network range/number.Abnormal response rcvd: An unexpected message was received from a WAN interface card. The included arefor problem reporting purposes only. If the system fails to operate normally, or the warningcontinues to occur, contact your Distributor or Customer Support.A call has exceeded the configured maximum durationA call has been up longer than the amount of time configured. The next log message will informthe user whether or not the call has been taken down.ACE authentication is not available. You must first ENABLE ACE user level authentication.An attempt was made to configure the Terminal Server Security for ACE and ACE was notconfigured on the CyberSWITCH.Adapter does not respond: adapter # ’x’The WAN card initialization subsystem encountered an error on the indicated adapter. Restart thesystem. If the problem persists, the indicated adapter card may be faulty and you should contactyour Distributor or Customer Support.Adapter # ’x’ failed to initializeThe operational software on the indicated adapter card failed to signal that initialization wascompleted. Restart the system. If the problem persists, the indicated adapter card may be faulty andyou should contact your Distributor or Customer Support.Adapter # ’x’ failed to respond from bootstrapThe WAN card initialization subsystem encountered an error on the indicated adapter whiledownloading the bootstrap program. Restart the system. If the problem persists, the indicatedadapter card may be faulty and you should contact your Distributor or Customer Support.Adapter failed to respond while programming: adapter 'x'The WAN card initialization subsystem encountered an error on the indicated adapter whileprogramming the hardware. Restart the system. If the problem persists, the indicated adapter cardmay be faulty and you should contact your Distributor or Customer Support.Administrative Session using ACE does not support password change.Passwords may only be changed via the ACE Server administrator initiation. During anadministrative login, the user attempted to change password. ACE only supports password changeinitiated by ACE Server administrator.AppleTalk routing initialized successfully.This message is posted when the system AppleTalk routing feature has initialized successfully. |
