| 
USER’S GUIDE536 CyberSWITCHNote that this command may be used in conjunction with all otherfr commands. For example,fr a 1 lmi would be a valid command, changing the frame relay access to 1 beforedisplaying information relating to the LMI link.fr d m>Sets an internal variable. m> will be the default DLCI under the currently-selectedaccess, and therefore the assumed context for all subsequent frame relay system consolecommands entered. <DLCI m> will remain the default DLCI until the default is changedthrough reissuing thefr d command. The DLCI value is provided by the serviceprovider at line subscription time.For the following frame relay commands, information is displayed for the currently selected access.However, you may also change the access (which, in turn, changes the default) by using thesecommands along with the access index command. Refer to thefr a n> command.fr displayDisplays the configuration information as entered during the last CFGEDIT session for thecurrently-selected frame relay access. Note that this also includes any configured PVCsassociated with this access.fr statsDisplays the statistics associated with the currently-selected access and DLCI. Refer to FrameRelay Statistics, for a list of available statistics and their definitions.fr clearClears the statistics counters associated with thefr stat command for the currently selectedaccess and DLCI.fr clearallClears all statistics associated with thefr stat command.fr lmiDisplays information relating to the LMI link on the currently-selected frame relay access, ifthat access has the layer Management Interface enabled. The following list describes the fieldsdisplayed when the FR LMI command is entered.LMI StateThe condition of the LMI link. Possible settings for this item are WAIT FULL STATUS (S1),WAIT T391 TIMEOUT (S2), and WAIT LIV STATUS (S3). The possible settings aredefined as follows:WAIT FULL STATUSThe LMI state entered when the local frame relay software has transmitted a STATUSENQUIRY message requesting a FULL REPORT STATUS message.WAIT T391 TIMEOUTThe LMI state entered when the local frame relay software has received a STATUS messagefrom the network in response to a previous STATUS ENQUIRY and has restarted the T391timer. (The T391 parameter is the configured Link Integrity Verification Timer.)WAIT LIV STATUSThe LMI state entered when the local frame relay software has transmitted a STATUSENQUIRY message requesting a LINK INTEGRITY VERIFICATION STATUS message. |
