Cabletron Systems CSX1200 User Manual

Also see for CyberSWITCH CSX1000: User guide Quick start

Contents

USER’S GUIDE526 CyberSWITCHdnetRequired parameter. The destination network number.dnodeRequired parameter. The destination node Id.timeoutOptional parameter. The number of seconds to wait for a reply message. The valid range isfrom 1 to 60 seconds. The default value is 10 seconds.nnnnOptional parameter. The data size to be included in the ping packet. The valid range for thedata size is 5 to 586 octets. The default value is 100 octets.An example atalk ping command could read as follows:atalk ping 1.3 30 /d200which would send a ping to node number 3 or network number 1, with a timeout value of 30seconds, and the data size would be 200 octets.atalk portThis command will display AppleTalk port information. A sample output screen is shownbelow:The fields in this display are defined as follows:typeThe port type. Possible types are LAN, WAN, WAN UnNumbered.Note that the WAN UnNumbered port information is not taken from the previously configuredAppleTalk Routing port information, but is derived from the AppleTalk Routing static routeconfiguration information.stateThe state of the port as it is in the process of coming up. Possible states include:listen - The port is listening to see if any other routers are out on the network.probing - The port is probing the network to see if its suggested AppleTalk address isunique, or if it is already in use.get_info - The port is verifying network information and obtaining the default zone.Port 1type: LAN state: UPaddress: 20.20 network range 20-21flags: extended phase-2 soft-seeddefault zone: zone1lan port: 1 physical address: 00409A001AB3Port 2type: WAN state: UPaddress: 30.30 network range 30-31flags: extended phase-2 soft-seeddefault zone: zone1Port 3type: WAN UNNUMBERED state: UPaddress: 20.20 (borrowed)remote device: MAC4