Cabletron Systems CSX1200 User Manual

Also see for CyberSWITCH CSX1000: User guide Quick start

Contents

Workgroup Remote Access Switch 171CONFIGURING D EVICE L EVEL DATABASESOn-node Device EntriesThe following table identifies the configuration requirements for possible security options forremote bridge devices.*Conditionally Required means you must specify at least one of either the Calling Line Id or theEthernet Address. You may specify both.IP Routing with HDLC Bridge DevicesTo allow devices to connect to the CyberSWITCH using IP routing through a Bridge device, youmust configure a RLAN Interface. IP routing must also be enabled. For each HDLC Bridge usingthis type of connection, you may need to enter the Device Name, Calling Line Id, Remote BridgeEthernet Address, Bridge Password, and IP (Sub) Network Number.The following table identifies the configuration requirements for possible security options for IPRouting with Bridge Devices.*Conditionally Required means you must specify at least one of either the Calling Line Id or theEthernet Address. You may specify both.Security Mode Configuration On-node Device Table Configuration DataCalling Line Id Bridge EthernetAddressCalling Line Id Bridge EthernetAddressBridge PasswordEnabled Disabled Required NotRequestedNot RequestedDisabled Enabled Not Requested Required Optional perdevice entryEnabled Enabled ConditionallyRequired*ConditionallyRequired*Optional perdevice entry(if entry specifiesan EthernetAddress)Security ModeConfigurationOn-node Device Table Configuration DataCallingLine IdBridgeEthernetAddressCalling Line Id BridgeEthernetAddressBridge Password IP (Sub) NetworkNumberEnabled Disabled Required NotRequestedNot Requested Required if only IPRouting is EnabledDisabled Enabled NotRequestedRequired Optional perdevice entryRequired if only IPRouting is EnabledEnabled Enabled ConditionallyRequired*ConditionallyRequired*Optional perdevice entry(if entryspecifies anEthernetAddress)Required if only IPRouting is Enabled