| 
USER’S GUIDE440 CyberSWITCHCNTR-TMR:Timed out waiting for TMR interrupt!The i386s specified timer did not respond during a POST testing its interrupt capabilities. The bootprocess should continue; however, make note of the error message in the event of a future problem.Configured adapter # ’x’ type does not existThe interface adapter indicated does not match the resource configuration in the system. Correctthe configuration on the system.Connection disconnected for license violationA connection was disconnected because there were more connections in place than allowed withyour version of the system software. A larger software version should be ordered.Could not find port for static route with next hop address Contact your distributor or Customer Support.Could not get Call Restriction informationContact your Distributor or Customer Support.Could not get current monthly charges informationCould not get the current monthly call charge information on the system. The call charge featurewill be disabled and the problem should be reported. Contact your Distributor or CustomerSupport.Could not obtain fcr packet bufferAppleTalk related. Contact your distributor or Customer Support.Couldn’t find speech service - An incoming call was received which specified Speech Bearer Service capability. Speech service isnot currently supported with the System. Most likely, the incoming call was a wrong number. Thesystem will attempt to treat the call as 56 Kbps data.Current monthly charges reset for new monthReported on the first day of the month to indicate that the current monthly call charges value isbeing reset to zero.Data link down: Slot= Port= CesThe data link on the specified line is down. If all the data links for a line are down, the line isdisabled for switched connection use.Data link test successful: DSL , CES 1This message applies for 1TR6 BRI only. If Layer 1 is established, a test will be done to determine ifthe data link can be established. This message indicates successful test results.Data link up: Slot= Port= Ces=The data link on the specified line is active and can be used for establishing switched connections.DCE Data Rate is invalid on FrStartPVCThe user has configured a data rate which is inconsistent with the application. This can only happenwith serial lines such as V.35 where the data rate must be specified in bits-per-second and theconfigured rate is not valid. |
