| 
Workgroup Remote Access Switch 499T RACE M ESSAGESX.25 Trace MessagesOut - X25 Call Accept LCN , bytesThe DTE is accepting an SVC call.Out - X25 Call Request LCN , bytesThe DTE is attempting to place an SVC call.Out - X25 Clear Ind LCN , bytesThe DCE is clearing the X.25 Virtual circuit on the indicated LCN.Out - X25 Clear Request LCN , bytesThe DTE is clearing the SVC call on the indicated LCN.Out - X25 CONNECTION REQUEST VcType= ConnId=Access= RemDteAddr=The system is sending a call request to the network.Out - X25 CONNECTION RESPONSE ConnId= Access=The system is sending a connection to the network. This is sent in response to receiving a callindication.Out - X25 DATA LCN , bytesData transfer.Out - X25 DISCONNECT REQUEST ConnId= Access= Cause=disconnect>The system is sending a disconnect to the network to terminate a call.Out - X25 DISCONNECT RESPONSE ConnId= Access=The system has received a disconnect response from the network.Out - X25 DTE Clear Conf LCN , bytesThe DTE is confirming that the virtual circuit on the indicated LCN has been cleared.Out - X25 DTE Interrupt LCN , bytesAn interrupt packet has been sent to the DCE. Flow control procedures do not apply to interruptpackets.Out - X25 DTE Intr Conf LCN , bytesThe DTE is confirming the reception of an interrupt packet from the DCE.Out - X25 DTE REJ LCN , bytesThe DTE has detected a packet sequence error.Out - X25 DTE Reset Conf LCN , bytesThe DTE is confirming that the virtual circuit has been reset.Out - X25 DTE Restart Conf LCN , bytesThe DTE is confirming that all virtual circuits have been reset.Out - X25 DTE RNR LCN , bytesThe DTE is not ready to receive more data packets. |
