Cabletron Systems CSX1200 User Manual

Also see for CyberSWITCH CSX1000: User guide Quick start

Contents

USER’S GUIDE518 CyberSWITCHspThis command pertains to semipermanent connections. This command will list eachsemipermanent device, as well as the connection status, initial data rate and current data ratefor each semipermanent device. The connection status will be one of the following:CONNECTEDThe system is connected to the device at the initial data rate or greater.OVERRIDDENThedisc device command was issued on this device. The system will not attempt to callagain until acall device command is issued, or the system is rebooted.N OT C ALLABLEThis device cannot be called. Check phone number, device type or existence of the device namein the database.REJECTEDThe remote device answered the system call, but rejected negotiations. The system stops callingattempts until acall device command is issued, or the system is rebooted.TRYINGThe system is attempting to call the device. Some connections may be up, but not at the initialdata rate.statusDisplays initialization, current status, and connection information, as well as any errors thathave been detected.led statusAllows you to view a snapshot of LED information from a remote terminal. It displays a verybasic ASCII rendering of the front of the system you are accessing. Each one of the WAN LEDsand the Service LED are labeled, and the state of each is indicated by an “O” for on, and a “.”for off.Note that if the B-channels on a line are flickering, you will only see the current state of theflicker. The image could actually represent a busy system that has every channel active, but theLEDs for all the channels just happen to be off the instant the “snapshot” was taken.Refer to the LED Indicators chapter for a more detail description of the LED indicators.timeDisplays the current system time. This can be useful when viewing system messages orstatistics.verDisplays the version number of the software that is currently running on the system (II, III,etc.). In addition, it displays all other custom information for this copy of the system software,such as the platform, the installed resources, and the hardware resource revision information.Note that T1_E1_PRI-1 indicates the PRI-23/30 adapter.